Philco 37-660 chassis question - Printable Version

+- The PHILCO Phorum (https://philcoradio.com/phorum)
+-- Forum: Philco Radio Discussions (https://philcoradio.com/phorum/forumdisplay.php?fid=5)
+--- Forum: Philco Electronic Restoration (https://philcoradio.com/phorum/forumdisplay.php?fid=8)
+--- Thread: Philco 37-660 chassis question (/showthread.php?tid=2401)

---

Philco 37-660 chassis question - Bill njb - 05-18-2010

I am looking for parts for this chassis and was wondering which other models used the same design as the 37-660.
I am trying to locate a replacement for the band select lever.
Thanks,
Bill

---

Re: Philco 37-660 chassis question - BDM - 06-01-2010

Bill, your best bet is to look here and compare specs. I'd imagine without looking, that many sets use the same switch. Quite a job to change out I might add with one of these "sub-chassis" sets.

http://www.nostalgiaair.org/Resources/303/T0000303.htm
EDIT: From what I can tell, your switch is unique to this set. The following part numbers are used

antenna rg(range) sw(switch)
42-1202

RF rg sw
42-1203

Oscillator rg sw
42-1204

Indexing plate & shaft
42-1186

If I'm reading this correctly, I couldn't find any other set using the same part numbers.

---

Re: Philco 37-660 chassis question - Bill njb - 06-02-2010

Thanks for your response. It looks like I may have to try and rebuild it. I have been asking around and haven't located a replacement for it.
Bill

---