Philco Model 60 - Printable Version

+- The PHILCO Phorum (https://philcoradio.com/phorum)
+-- Forum: Philco Radio Discussions (https://philcoradio.com/phorum/forumdisplay.php?fid=5)
+--- Forum: Philco Electronic Restoration (https://philcoradio.com/phorum/forumdisplay.php?fid=8)
+--- Thread: Philco Model 60 (/showthread.php?tid=6139)

---

Philco Model 60 - Bob - 03-05-2013

Hi
I am working on a Philco Model 60. I am starting by replacing the Electrolytic caps #45 & 46 on the service bulletin #164. I notice that the #45 cap had been replaced before. The schematic shows the minus ends of the caps tied together, the 45 cap minus had been grounded. Should I make it like the print or was this grounded for a reason?
Thanks Bob

---

RE: Philco Model 60 - morzh - 03-05-2013

The print makes sense.

---

RE: Philco Model 60 - Ron Ramirez - 03-06-2013

Connect the negatives of the electrolytics as shown on the schematic, else you will have an annoying hum you will never be able to get rid of.

---

RE: Philco Model 60 - Bob - 03-06-2013

Thank you Guys
I'll make it like the "print". I am just starting this rehab , so I will probably be back for more help.
Thanks Again Bob

---

RE: Philco Model 60 - codefox1 - 03-06-2013

So long as the radio is in rehab and you are not, good!

---