Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Zenith 6S229 Tombstone
#46

Ok, You hit it right on the head. I forgot to clean the band-switch. I thought I did but apparently NOT..


After cleaning the SW bands started to work. I went back and realigned the IF and now motor boating is gone. Sensitivity has improved also. I did change out the 6A8 tube and that helped a lot on SW bands..

Only thing now I need is some Grill cloth as mine is in pretty bad shape..

See photo.. Cannot seem to find this pattern anywhere...


[Image: http://i292.photobucket.com/albums/mm38/...iustig.jpg]


Skip...
#47

About the closest I see is the New Leaf pattern from Kenny Richmond:

http://www.richmonddesignsinc.com/grille...oduct_page

   

While not entirely correct, I think the Philco 90 style (Whiskey Rayon) would look good in it also.

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"
#48

I would think this is a better match.. That one is too "Booom! here i am..."

http://www.richmonddesignsinc.com/yahoo_..._large.jpg
[Image: http://www.richmonddesignsinc.com/yahoo_..._large.jpg]

Times I have been electrocuted in 2021
As of 1/01/2021
AC: 4 DC: 1
Last year: 6
#49

kirks
looks about right lighter, similar shape Icon_thumbup

sam

Some day, and that day may never come, I will call upon you to do a service for me. But until that day, accept this justice as a gift
mafiamen2
#50

Here is a pretty good picture of what it looked like new:

http://www.radiophile.com/6s229.htm

There still isn't an exact match being made right now, but the Zenith swirl pattern Kirk posted might be a better option.

I think the Zenith pattern #68 that grillecloth.com use to carry was a pretty decent match to what you have now, but that is no longer available.

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"
#51

Dye it with coffee.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#52

ALL, Thanks I ordered the one from Richmonddesign the Sam posted.

Since its a 18 X 24 in piece and I only need about 9 X 9 in. I might try the Dye..

Last thing I need to do before I put it back in cabinet..


Skip...
#53

http://www.ebay.com/itm/Vintage-Speaker-...SwA3dYHnMl

Zenith but darker tone.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#54

All, I was going over this again.. Before I put in cabinet.. Checking alignment ..

Noticed this.. The Tracking across the bands..

Broadcast Band  

From 1700-1100 Tracking is right on..
From 1100-500  Tracking is of 20 Khz high..

SW One..

From 1.8-3.2  Tracking Right on..
From 3.2-6    Tracking about 20-30 KHZ low..

SW Two

From 6.0-9.0  Right on
From 9.0-18.0  Tracking 20Khz high

This was checked with a calibrated generator input to radio was -63 Dbm

Question is what would cause the Tracking issues?  Something common to all bands.. Seems like 1/2 of all bands are good other half not so..

Skip..
#55

It's a little odd to have the same amount of discrepancy on both sw bands as you know the same amount capacity will have more effect as the frequency increases. Anyway you should be able to correct the bcb adjusting J to being the low end in tune. Would consider +/- 5 good on the bcb and 10kc on the sw bands.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#56

Terry, Great thanks again..

Skip




Users browsing this thread: 1 Guest(s)