Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

rare "1-off" Zenith mystery chassis? trying to ID
#1

I have a "mystery" ??? simple Zenith ac/dc chassis with no "model #"sticker on bakelite cab to match orig Zenith chassis # factory sticker located on chassis. Fact is, I cant find this Zenith chassis listed in JF Riders, or anywhere else on the internet,radioattic,eBay,Zenith collectors websites,etc period. This mystery Zenith bakelite ac/dc set is a AM / Shortwave factory orig combo. This sets chassis is identical layout ,as the more-common seen on eBay AM band only version Zenith mod 5D-810 Y., only differences is this mystery set uses a 50C5 in place of the 50L6, and has no factory loop antenna built-in as the 5D810 (no diallamp) & 5D-811(with diallamp), and has the Zenith factory orig rotary AM/ SW bandswitch on rear of chassis.The orig bakelight cabinet is the same as the 5D-810Y ( with no handle on top as the 5D-811)
see a photo here of the more-common 5D-810Y:

http://www.radioattic.com/radio.php?radio=7531

The orig Zenith chassis # sticker on my "mystery" Zenith is still in place reads chassis #: 5G60T for this 2-band ( AM/SW set) Ive never seen one of these sets before, period. Is this particular set "rare"?? HELP Zenith pros!!!

the Zenith chassis # for the more common AM only ac/dc chassis receivers ( mods 5D-810Y & 5D-811)models are listed in JF Riders index respectively as: chassis #s 5E02, & 5E01 and both schematics are in Riders vol 18

....another "notable" difference in these 3 ac/dc sets mentioned, is the fact that my "mystery set" chassis has the orig Zenith "bumblebee" black early sealed type caps, as opposed to the AM receivers orig "wax" types used at the factory in the AM only sets. And as mention previous above, the "mystery" chassis came with no factory loop antenna. Just 2 separate wires off the antenna coil to attach to a longwire as orig.

Any Zenith pros out there ever ran across the Zenith 5G60T chassis before? I have the set fully restored, but would like to know more about it, its "scarcity", etc? Perhaps this particular model only showed up in the official Zenith-service books from the 1947,48,49 years? It is a very fine receiver indeed on both AM & SW! Icon_wink
#2

If I'm not mistaken, the T suffix indicates an export model on later (postwar) models. That makes the info hunt more difficult.
#3

Thanks for the info Exray!! I thought it was kinda weird that Zenith would add the SW band that many yrs (postwar) also on the cheaper bakelite tabletop models, since the American counterpart was AM only during 1948-49 yrs. Zeniths SW sets for Americans was still the mainstream Transoceanics-line during those yrs and cost much more. This set was most probably brought back to the US by a military veteran that purchased it overseas while on tour of duty. Many Telefunkens, Grundigs,Emud etc also made it here to the US over the yrs in US Military shipping crates. I also noticed the chassis on this mystery set also has the Zenith (gold-wrinkle finish) Transoceanic-type chassis paint job that the counterpart US models were alum chassis only. Thanks again for your info on the (export) model Zeniths!!I figure there probably werent many of these bakelight export models made, but then again, these type sets are not worth much anyways except for the history behind them. Icon_wink




Users browsing this thread:
[-]
Recent Posts
5U4 vs 5Z4 tubes
The pinout is the same but the 5U4 has a 3 amp filament, verses 2 amps or less on the 5Z4. I think that the pinout of a ...Arran — 12:04 AM
Philco 42-345 Restoration/Repair
By the way. osanders0311 Take a look here: Dial cord stringing Guides May be here you can fount correct string settin...Vlad95 — 11:15 PM
5U4 vs 5Z4 tubes
5U4 and 5Z4 almost identical. I think nothing happened if you left 5U4 instedad 5Z4 long time. Just heater current 5U4 ...Vlad95 — 11:02 PM
Philco 42-345 Restoration/Repair
Hello Vlad95 , Very Funny ! Sincerely Richardradiorich — 11:01 PM
Philco 42-345 Restoration/Repair
RodB You are European yourself   :evil: I'm Canadian for the last 30 years  :snowman: But not Yankee  :lol: Vlad95 — 10:49 PM
Philco 42-345 Restoration/Repair
The band switch selects different oscillator coils for the band selected. I would look for a bad connection in the switc...RodB — 10:31 PM
Philco 42-345 Restoration/Repair
Hang in there...PaulPaul Philco322 — 09:30 PM
Philco 42-345 Restoration/Repair
The thrill is gone again, thought I was close to being done with it. Well Friday it was receiving broadcast, Saturday mo...osanders0311 — 07:47 PM
Help with Supreme 599
Iam getting closer to fixing it. I bumped Up the tranny voltage to get 5v on the 80 tube. I gan get the needle to move ...daveone23 — 03:41 PM
Philco 42-345 Restoration/Repair
Hello RodB, Checking my previous post I realized you're the one with the 42-340. I replaced the string for the tuning...osanders0311 — 03:12 PM

[-]
Who's Online
There are currently no members online.

>