Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Northern Electric 1121
#1

I am picking up this one next week.
 It has 11 tubes with push pull 6V6 tubes and a 5X4 for a rectifier.
Five bands, and a nice cabinet. It is called  the ''London''
 I already have the '' Bombay'' [last photo] which I have refinished.
  Just like a kid at Christmas I can't wait.
 Dan in Calgary


Attached Files Image(s)
               

   Living in Calgary Alberta
#2

Dan;
   It looks like they used a piece of TenTest/Donnaconda/Homasote board over the back of the speaker compartment, which is still available should anyone need some. 
Regards
Arran
#3

Nice find Dan,

I had a Vimy. I gave it to a friend. I don't know if it survived the divorce.

cheers
#4

Dan;
    Your Northern Electric "London" looks like it was the recipient of a strip n' clearcoat job, the dial also looks like you may have to get a replacement made at radiodaze. Those mid 30's N.E sets are notorious for their use of water based paint on their dials, lucky that Radiodaze can probably use a scan of the " Bombay" dial as a basis for the missing lettering.
Regards
Arran




Users browsing this thread:
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
So one last question before I finish this radio. Regarding the speaker and output transformer. I salvaged the original o...Stormlord5500 — 09:31 AM
462ron
It’s on the bottom of the homepage of our Philcoradio.com homepage! Ron462ron — 07:20 AM
Model 70 Cabinet Trim
Steve might have some trim left. Not sure he is making anything.morzh — 06:12 AM
Model 70 Cabinet Trim
Hello musar, First all welcome to the forum and yes that is true that steve stopped making trim . Sincerely Richar...radiorich — 12:13 AM
Model 70 Cabinet Trim
I have recently come into possession of a Model 70.  The trim around the base needs to be replaced.  If this were years ...musar — 12:07 AM
philcorepairbench.com - shadow-meter
Anyone know of a way to recover these files from the repair bench? Thanks. fenbach — 11:16 PM
Philco model 38 code 121 not receiving signal.
That's true. Of course If I were to get a vtvm I'd probably have to sink money in to it to get it working right. Probabl...Stormlord5500 — 08:44 PM
Philco model 38 code 121 not receiving signal.
A DMM is good enough. One rarely has to measure indictance, but if you do, short of getting a serious LCR meter (I hav...morzh — 07:35 PM
Testing a speaker and output transformer Trutone A2-G
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now. Have better volu...murf — 03:43 PM
Philco model 38 code 121 not receiving signal.
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM

[-]
Who's Online
There are currently 560 online users. [Complete List]
» 2 Member(s) | 558 Guest(s)
AvatarAvatar

>