Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Could these tubes be the originals?
#1

I have a Philco 66 on the bench. While testing the tubes, I noticed that ALL were branded PHILCO and had similar appearance and date codes. I had no luck on finding information on the web for early Philco tubes. This radio had had some servicing (volume control, line bypass cap) but was otherwise all original.

I was wondering if the tubes were the originals as shipped? All the codes are arranged vertically, with a LETTER and a NUMBER. The codes I found were (first figure on TOP) 78: 5C, 6A7: H5, 75: C5, 42: B4, 80: B4. Looks like a month (letter) and year (number) - but just guessing.

Does anyone have a reference on-line? I do NOT have Lud's book.

Thanks,
Dave
#2

The number is the last digit of the year. Letters are months: C is January, B is October and H is February. After September 1935 the month codes changed: B is February, C is March, H is August.

In either case it seems odd to have dates so far apart (I'm quite sure Philco did not stockpile tubes for months).

These are Sylvania codes, and it's possible Philco bought tubes from someone else, which would have different codes.
#3

Is this information in the book Tube Lore or another source? It is just curious that at least the YEAR is close to the introduction date of the radio. I would not suspect that the tubes would have been changed so soon. And they are all branded Philco.

Thanks!




Users browsing this thread:
[-]
Recent Posts
Restoration of the Canadian General Electric A-87
Well... While the varnish is drying up, I started repairing the chassis... Of course I started by replacing the pa...RadioSvit — 07:12 AM
Philco Model 38-7: what caps & resistors do fail typically?
Hello Martin, Welcome aboard our little community what great Model 38-7 Sincerely Richardradiorich — 12:30 AM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum Martin. I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM
Part numbers to model cross
Jim, We have this index put together by Dale Cook but I don't think that is quite what you are looking for. The Parts...klondike98 — 09:37 PM
Philco Model 38-7: what caps & resistors do fail typically?
Yep the dim bulb test is OK but I'd definitely replace all those electrolytics before I did it. Since those #47 conden...klondike98 — 09:18 PM
Philco 42-345 Restoration/Repair
The resistor is a 2.2 Meg, it was the last one I hadn't replaced. The broadcast is coming in after replacing it.osanders0311 — 09:09 PM
Philco 42-345 Restoration/Repair
What does the resistor measure? I think it should be 3.3 Meg. If the oscillator coil has continuity and the resistanc...RodB — 09:03 PM
Philco Model 38-7: what caps & resistors do fail typically?
Good idea to check the coils... then I'll get hold of an incadescent light bulb and see what happens when the unit is sw...Musaeum — 08:49 PM
Philco 42-345 Restoration/Repair
I have that same set, ain't too much shortwave I like anyway.....it is a good AM DX set. PaulPaul Philco322 — 08:32 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum, Martin! Open a new thread in Philco Electronic Restoration when you begin working on your 38-7. ...GarySP — 08:28 PM

[-]
Who's Online
There are currently 1259 online users. [Complete List]
» 1 Member(s) | 1258 Guest(s)
Avatar

>