Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

38-38 Mystery Part
#1

I'm considering picking up two consoles this weekend. My interest is mainly in a 610.  Due to a proviso that 'both must go,' I'm towing a 38-38 along with me. It will be my introduction to the farm radio experience which I am mildly excited about. I asked the seller if the radio had been upgraded for AC use only because he said it last played about ten years ago (haven't they all?) Anyway, he said it had a cord and plug and I noticed a contraption in the bottom of the cabinet which I did not recognize (see attached.) Can anyone please educate me on the purpose of this mystery part? Thanks in advance.


Attached Files Image(s)
   
#2

Looks like a power pack to allow operation on mains power. http://www.nostalgiaair.org/Resources/248/M0013248.htm     Looks like a fun project, or it could be the flux capacitor out of a time machine! Some more info https://philcoradio.com/phorum/showthread.php?tid=21485
#3

Thanks for the info David. That sounds promising about the former. Hedging my bets, does Riders contain a schematic for the latter? I may need it to go back and pick up the former.
#4

Might be one of these: http://www.nostalgiaair.org/pagesbymodel...017907.pdf

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#5

Great. Thanks Terry! I will definitely pore over that literature. I'm very green on radio repair in general so this will be a big help in trying to understand how these adaptors work.
#6

Some more info on a battery eliminator   https://philcoradio.com/phorum/showthread.php?tid=21451
#7

Thanks David and Terry for pointing me in the right direction on this. You guys were right on, as expected. I saw the Sears silvertone and Electro (pictured below) models of the battery eliminator and they look almost identical to the image I have. Thanks again, I really appreciate your help.


Attached Files Image(s)
       




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
So one last question before I finish this radio. Regarding the speaker and output transformer. I salvaged the original o...Stormlord5500 — 09:31 AM
462ron
It’s on the bottom of the homepage of our Philcoradio.com homepage! Ron462ron — 07:20 AM
Model 70 Cabinet Trim
Steve might have some trim left. Not sure he is making anything.morzh — 06:12 AM
Model 70 Cabinet Trim
Hello musar, First all welcome to the forum and yes that is true that steve stopped making trim . Sincerely Richar...radiorich — 12:13 AM
Model 70 Cabinet Trim
I have recently come into possession of a Model 70.  The trim around the base needs to be replaced.  If this were years ...musar — 12:07 AM
philcorepairbench.com - shadow-meter
Anyone know of a way to recover these files from the repair bench? Thanks. fenbach — 11:16 PM
Philco model 38 code 121 not receiving signal.
That's true. Of course If I were to get a vtvm I'd probably have to sink money in to it to get it working right. Probabl...Stormlord5500 — 08:44 PM
Philco model 38 code 121 not receiving signal.
A DMM is good enough. One rarely has to measure indictance, but if you do, short of getting a serious LCR meter (I hav...morzh — 07:35 PM
Testing a speaker and output transformer Trutone A2-G
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now. Have better volu...murf — 03:43 PM
Philco model 38 code 121 not receiving signal.
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM

[-]
Who's Online
There are currently 384 online users. [Complete List]
» 1 Member(s) | 383 Guest(s)
Avatar

>