Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Zenith 809 lacquer color scheme?
#1

Hello Experts, 

I'm refinishing a Zenith tombstone model 809. It was once ZOWIE! looking. I hope to make it look good again. It must have spent time in a damp environment.  I'm having the front speaker grill chromed. I'm interested in some opinions on original lacquer colors. I've seen a few online photo of the radio that have perhaps been refinished. From the original finish, and I did document it, I can see a couple of tones as well as almost black on some trim and edges. I wonder if anyone has researched or has one of these Art Deco babies in excellent condition. I would appreciate some opinions. 

Thanks, 

Dave
#2

Are the grilles in those actually chrome plated, or are they nickel plated, or polished aluminum?
Regards
Arran
#3

It is chrome. I cleaned it up with naval jelly. I took it to a plating company, and they're going to re plate it for me. The cabinet is looking good. It will look stunning.
#4

Depending on how corroded the chrome is, sometimes it's cheaper making a new part out of brass, and having that plated. The only sets I have with chrome parts are some transistor portables, and a trio of Canadian RCA A-20s, the chrome on the A-20s is like a car bumper, very thick. I think that chrome and aluminum speaker grilles was more popular in Europe, you can count the number of North American radios with them on two hands. At least it isn't all show the chassis has a tuned RF amplifier stage like an RCA 128.
Regards
Arran




Users browsing this thread:
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2207 online users. [Complete List]
» 1 Member(s) | 2206 Guest(s)
Avatar

>