Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 650 Chairside Radio
#1

I just acquired a Philco model 650 Chairside radio. Eight ( 8 ) tubes , original knobs (Yea!) and cabinet intact. I cannot locate ANY data on this radio. I also find the radio interesting as it had no grille cloths ... the outlet grills on all sides were backed by "baffle boards" ca. 1/4 inch from the inside cabinet. Unfortunately, the original speaker(s) were replaced by more moden permanent magnet type speaker.

Any and all information on this interesting radio will be greatly appreciated.

Regards, all,

Frank
#2

Hi

Great acquisition! I had one of those a few years ago...wish I had kept it.

I have some info on the 650RX here:
http://www.philcoradio.com/gallery/1936a.htm#an

I seem to recall that the separate speaker cabinet originally used a permanent magnet speaker, and it used a choke instead of a field coil.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
So one last question before I finish this radio. Regarding the speaker and output transformer. I salvaged the original o...Stormlord5500 — 09:31 AM
462ron
It’s on the bottom of the homepage of our Philcoradio.com homepage! Ron462ron — 07:20 AM
Model 70 Cabinet Trim
Steve might have some trim left. Not sure he is making anything.morzh — 06:12 AM
Model 70 Cabinet Trim
Hello musar, First all welcome to the forum and yes that is true that steve stopped making trim . Sincerely Richar...radiorich — 12:13 AM
Model 70 Cabinet Trim
I have recently come into possession of a Model 70.  The trim around the base needs to be replaced.  If this were years ...musar — 12:07 AM
philcorepairbench.com - shadow-meter
Anyone know of a way to recover these files from the repair bench? Thanks. fenbach — 11:16 PM
Philco model 38 code 121 not receiving signal.
That's true. Of course If I were to get a vtvm I'd probably have to sink money in to it to get it working right. Probabl...Stormlord5500 — 08:44 PM
Philco model 38 code 121 not receiving signal.
A DMM is good enough. One rarely has to measure indictance, but if you do, short of getting a serious LCR meter (I hav...morzh — 07:35 PM
Testing a speaker and output transformer Trutone A2-G
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now. Have better volu...murf — 03:43 PM
Philco model 38 code 121 not receiving signal.
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM

[-]
Who's Online
There are currently 376 online users. [Complete List]
» 1 Member(s) | 375 Guest(s)
Avatar

>