Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

37-60B?
#1

I came across a tombstone today at an antique market today, I think that it was a 37-60B. Cosmetically it was in excellent condition. It was missing a couple of tubes and the sockets of said tubes were loose, but otherwise it looked pretty much unmolested. I'm considering making an offer on it, but would like to get a few opinions on this set and it's value. Thanks.
-Dave
#2

Hi

The 37-60 is not the most desirable Philco out there, but it certainly isn't the worst. With five tubes, it is a good performer.

The important thing here, is whether or not the photofinished front panel is still in good condition, or not. Here is a late version 37-60B with excellent photofinish:

http://www.philcoradio.com/gallery/1937b.htm#j

If the one you are looking at has good photofinish, you should grab it if the price isn't ridiculously high. How much $$ is the seller asking for it?

--
Ron Ramirez
Ferdinand IN
#3

$75.00. I wish that I had taken a few pictures of it. The only external damage that I saw was the dial cover was loose. Finish looked good & appeared all original. Couldn't see much of the inside because it wasn't under very good lighting.
It looks like the 37-60B on the June '36 + page.
#4

Motorola man Wrote:It looks like the 37-60B on the June '36 + page.
In that case, it is a cathedral, not a tombstone. Cathedral = rounded top, tombstone = flat top.

If the photofinish is intact and the chassis isn't rusty, go for it. I've seen lots of 37-60 and 37-61 cathedrals on eBay with the photofinish completely stripped off. These, to me, are worth a lot less than a nice original that still has its photofinish intact.

--
Ron Ramirez
Ferdinand IN
#5

I realized my faux pas after my post, it is a cathedral. Thanks for the clarification though. I went back today & took a closer look & took a few pictures. I was mistaken on which model it is, it's actually a 37-61. I think I'm going to make an offer on it & see what happens.
#6

Good! The 37-61 is better than a 37-60 in that the 37-61 has a better SW band - 5.7 to 18.2 mc, as opposed to 2.3 to 7.4 mc on the 37-60. Plus, the 37-61 has two-speed tuning with dual concentric tuning knobs, which makes it easier to tune on the SW band.

Good luck.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Model 70 Cabinet Trim
Hello musar, First all welcome to the forum and yes that is true that steve stopped making trim . Sincerely Richar...radiorich — 12:13 AM
Model 70 Cabinet Trim
I have recently come into possession of a Model 70.  The trim around the base needs to be replaced.  If this were years ...musar — 12:07 AM
philcorepairbench.com - shadow-meter
Anyone know of a way to recover these files from the repair bench? Thanks. fenbach — 11:16 PM
Philco model 38 code 121 not receiving signal.
That's true. Of course If I were to get a vtvm I'd probably have to sink money in to it to get it working right. Probabl...Stormlord5500 — 08:44 PM
Philco model 38 code 121 not receiving signal.
A DMM is good enough. One rarely has to measure indictance, but if you do, short of getting a serious LCR meter (I hav...morzh — 07:35 PM
Testing a speaker and output transformer Trutone A2-G
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now. Have better volu...murf — 03:43 PM
Philco model 38 code 121 not receiving signal.
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM
Philco model 38 code 121 not receiving signal.
I use a pair of Mastercraft brand DMMs from Canadian Tire, from what I read most of those DMMs use the same main chip re...Arran — 02:36 PM
Philco model 38 code 121 not receiving signal.
Thank you sir. Yes I feel good and also relieved because this one's been weighing on me a bit.Stormlord5500 — 11:18 AM
Philco model 38 code 121 not receiving signal.
It feels good don't it? Good luck on the rest.Paul Philco322 — 11:06 AM

[-]
Who's Online
There are currently no members online.

>