Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

37-116 odd problem, even odder fix.
#1

This thing would not stay aligned. Would align it and 790 would be dead on a few days later it was at 840, next day 870 and jumped to 910 while I was listening to it. WWV(H) went from 15 to 15.4. Icon_eek

Tried to realign it several times but it would jump again.

Was about ready to take the RF subchassis out. Thought I would try measuring the LO at the grid cap of the mixer (6L7G) LO freq looked ok Icon_crazy so why wont it work??? Woops now 790 is at 730!!

So I replaced the wire from the tuning gang to the grid of the 6L7G and realigned it and its stable and dead on on all bands. Seems the solder joint was bad on the grid cap connector, and the LO didn't like the changing load.

6' of wire for an antenna and I was listening to the voice of Russia on 15.425 (great classical music) and at dusk I was getting WWV and WWVH at the same time on 5 and 15 MHz. Wonder what this would do with a proper antenna?

John
Las Vegas, NV USA




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
philcorepairbench.com - shadow-meter
Anyone know of a way to recover these files from the repair bench? Thanks. fenbach — 11:16 PM
Philco model 38 code 121 not receiving signal.
That's true. Of course If I were to get a vtvm I'd probably have to sink money in to it to get it working right. Probabl...Stormlord5500 — 08:44 PM
Philco model 38 code 121 not receiving signal.
A DMM is good enough. One rarely has to measure indictance, but if you do, short of getting a serious LCR meter (I hav...morzh — 07:35 PM
Testing a speaker and output transformer Trutone A2-G
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now. Have better volu...murf — 03:43 PM
Philco model 38 code 121 not receiving signal.
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM
Philco model 38 code 121 not receiving signal.
I use a pair of Mastercraft brand DMMs from Canadian Tire, from what I read most of those DMMs use the same main chip re...Arran — 02:36 PM
Philco model 38 code 121 not receiving signal.
Thank you sir. Yes I feel good and also relieved because this one's been weighing on me a bit.Stormlord5500 — 11:18 AM
Philco model 38 code 121 not receiving signal.
It feels good don't it? Good luck on the rest.Paul Philco322 — 11:06 AM
Philco model 38 code 121 not receiving signal.
I've reinstalled the coil. Now IT'S ALIVE!!!!!! I fired up my TinySA on signal generator mode and set it to 1400Kc and ...Stormlord5500 — 11:01 AM
Philco model 38 code 121 not receiving signal.
Yes, Walmart, right up there with Fluke.RodB — 11:00 AM

[-]
Who's Online
There are currently 2101 online users. [Complete List]
» 2 Member(s) | 2099 Guest(s)
AvatarAvatar

>