Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

inquiry
#1

Total Newbie to vintage radios. I have been asked by a relative to see if these 2 console radios have any value.
Model 650X (as near as I can determine)
Model 41-280

Both are in reasonably restorable shape. My Aunt claims that my uncle listened to them often over the years, but has not for approximately 5. I was reluctant to plug them in and try them, but will soon when I return.
They are located in Myrtle Beach,SC. I am in NY.

Thanks
#2

Hi and welcome!

First off DO NOT PLUG IN THOSE SETS!

You can cause irreparable and permanent damage or
worse.

The sets need to be fully restored by a knowledgeable antique radio repair person.

Find an antique radio club near you. Many clubs offer or have persons who can help you with restoration.

Both sets are "keepers". The 1936 Model 650X is especially a good set - well worth restoring. Value is priceless, since it's in the family.

Same with the 1941 Model 41-280 console. You can't put a value on them, since they are heirlooms. Those sets have a family history and it's good that you're getting them back to working condition.

Chuck
#3

Monetarily the 650X is worth more then the 41-280 but it's still not a high dollar set. If they have been in the family since new that makes them worth more to you then to someone else. Both are decent performing sets when they are working properly, but the 650X would be easier to work one as it won't need to be rewired.
Regards
Arran




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Restoration of the Canadian General Electric A-87
Well... While the varnish is drying up, I started repairing the chassis... Of course I started by replacing the pa...RadioSvit — 07:12 AM
Philco Model 38-7: what caps & resistors do fail typically?
Hello Martin, Welcome aboard our little community what great Model 38-7 Sincerely Richardradiorich — 12:30 AM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum Martin. I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM
Part numbers to model cross
Jim, We have this index put together by Dale Cook but I don't think that is quite what you are looking for. The Parts...klondike98 — 09:37 PM
Philco Model 38-7: what caps & resistors do fail typically?
Yep the dim bulb test is OK but I'd definitely replace all those electrolytics before I did it. Since those #47 conden...klondike98 — 09:18 PM
Philco 42-345 Restoration/Repair
The resistor is a 2.2 Meg, it was the last one I hadn't replaced. The broadcast is coming in after replacing it.osanders0311 — 09:09 PM
Philco 42-345 Restoration/Repair
What does the resistor measure? I think it should be 3.3 Meg. If the oscillator coil has continuity and the resistanc...RodB — 09:03 PM
Philco Model 38-7: what caps & resistors do fail typically?
Good idea to check the coils... then I'll get hold of an incadescent light bulb and see what happens when the unit is sw...Musaeum — 08:49 PM
Philco 42-345 Restoration/Repair
I have that same set, ain't too much shortwave I like anyway.....it is a good AM DX set. PaulPaul Philco322 — 08:32 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum, Martin! Open a new thread in Philco Electronic Restoration when you begin working on your 38-7. ...GarySP — 08:28 PM

[-]
Who's Online
There are currently 1260 online users. [Complete List]
» 1 Member(s) | 1259 Guest(s)
Avatar

>