Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 42-365
#1

I'm a new to the forum ...... experienced in electronics, but all post tube era. I acquired a 42-365 when moving my parents from their home to assisted living. The cabinet is in very good condition ...... but would look nicer with a restoration. There is a loud constant hum ( independent of volume) which Ron tells me is likely the electrolytics. I don't see much discussion on this model. Are there a lot of these around? Is it an uncommon model?
#2

http://www.philcoradio.com/gallery/1942a.htm

Not a real common set...but not a desirable one, either, from a collectibility standpoint. I have one like yours, either a 42-365 or 360, don't really remember right now. It was given to me by a good friend...I do not plan to restore it, but will use it for parts. Its cabinet is pretty much shot.

Do replace those electrolytics, and ALL paper capacitors as well. The old rubber insulation on the wiring will also have to be addressed.

Good luck, and enjoy!

--
Ron Ramirez
Ferdinand IN




Users browsing this thread:
[-]
Recent Posts
Restoration of the Canadian General Electric A-87
Well... The console body has been restored, while the varnish dries reliably I started repairing the chassis.. ...RadioSvit — 07:12 AM
Philco Model 38-7: what caps & resistors do fail typically?
Hello Martin, Welcome aboard our little community what great Model 38-7 Sincerely Richardradiorich — 12:30 AM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum Martin. I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM
Part numbers to model cross
Jim, We have this index put together by Dale Cook but I don't think that is quite what you are looking for. The Parts...klondike98 — 09:37 PM
Philco Model 38-7: what caps & resistors do fail typically?
Yep the dim bulb test is OK but I'd definitely replace all those electrolytics before I did it. Since those #47 conden...klondike98 — 09:18 PM
Philco 42-345 Restoration/Repair
The resistor is a 2.2 Meg, it was the last one I hadn't replaced. The broadcast is coming in after replacing it.osanders0311 — 09:09 PM
Philco 42-345 Restoration/Repair
What does the resistor measure? I think it should be 3.3 Meg. If the oscillator coil has continuity and the resistanc...RodB — 09:03 PM
Philco Model 38-7: what caps & resistors do fail typically?
Good idea to check the coils... then I'll get hold of an incadescent light bulb and see what happens when the unit is sw...Musaeum — 08:49 PM
Philco 42-345 Restoration/Repair
I have that same set, ain't too much shortwave I like anyway.....it is a good AM DX set. PaulPaul Philco322 — 08:32 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum, Martin! Open a new thread in Philco Electronic Restoration when you begin working on your 38-7. ...GarySP — 08:28 PM

[-]
Who's Online
There are currently 924 online users. [Complete List]
» 2 Member(s) | 922 Guest(s)
AvatarAvatar

>