1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
41-610 121 light string gudie for the bands
Jeffb1960
Junior Member
**
Posts: 6
Threads: 1
Joined: Feb 2015
City: Gulfport, MS
#16

02-15-2015, 11:50 AM
mine had a spring and thank you again
Find
K7Sparky
Member
***
Posts: 61
Threads: 5
Joined: Mar 2014
City: Holiday TN
#17

02-23-2015, 08:47 PM
You are correct Ron, There is a spring.

The dial cord on the light is also heavier than the regular tuning pointer.

I finally found a metalized cord that holds to the light OK.  It just fits under the tab in the light.  The light slides on regular dial cord.  I still have the original broken cord in the picture and can mike it if you need the diameter.

If you need a bit of what I used PM me with the length you need, I can measure the broken cord that came off my 41-280 or say a foot and your snail mail.  You can donate what ever you think it's worth & the postage to the forum when you get it.

[Image: http://i1356.photobucket.com/albums/q734...90964f.jpg]
Taken as restoration started

Don't have a picture after the replacement
(This post was last modified: 02-23-2015, 08:54 PM by K7Sparky.)
Find
« Next Oldest | Next Newest »
Thread Closed




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2264 online users. [Complete List]
» 2 Member(s) | 2262 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration