Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 39-116RX
#1

I have a chance at buying a 39-116RX with a working remote.
I saw the radio and it does work, the remote dial has very little warp.
First question, any ideas on a fair price and the second is how the remote can work
since nobody has ever put a battery in it????

Here's another fine mess you have gotten me into. Oliver Norville Hardy.
#2

(12-16-2015, 04:45 PM)Scottb Wrote:  I have a chance at buying a 39-116RX with a working remote.
I saw the radio and it does work, the remote dial has very little warp.
First question, any ideas on a fair price and the second is how the remote can work
since nobody has ever put a battery in it????

 Do you know what they are asking for it? Is the cabinet in nice shape? Does it need refinishing? As for it working it may seem to work now, but if it hasn't been restored electrically it's living on borrowed time, plus it has yards of rubber/gutta percha covered wire run throughout the chassis which may be deteriorating by now, so I would not pay a premium for it. If it still has the remote control that's a bonus, although the remote control boxes for these are not that hard to find.
  The remote control itself has a small transmitter with a tube inside, a type #30 I think, and when you dial a number on the control it sends out a series of pulses via longwave which is picked up by a corresponding receiver on the radio chassis. Since it has a tube it requires an "A" and a "B" voltage from a battery pack.
Regards
Arran




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco Model 38-7: what caps & resistors do fail typically?
Hello Martin, Welcome aboard our little community what great Model 38-7 Sincerely Richardradiorich — 12:30 AM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum Martin. I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM
Part numbers to model cross
Jim, We have this index put together by Dale Cook but I don't think that is quite what you are looking for. The Parts...klondike98 — 09:37 PM
Philco Model 38-7: what caps & resistors do fail typically?
Yep the dim bulb test is OK but I'd definitely replace all those electrolytics before I did it. Since those #47 conden...klondike98 — 09:18 PM
Philco 42-345 Restoration/Repair
The resistor is a 2.2 Meg, it was the last one I hadn't replaced. The broadcast is coming in after replacing it.osanders0311 — 09:09 PM
Philco 42-345 Restoration/Repair
What does the resistor measure? I think it should be 3.3 Meg. If the oscillator coil has continuity and the resistanc...RodB — 09:03 PM
Philco Model 38-7: what caps & resistors do fail typically?
Good idea to check the coils... then I'll get hold of an incadescent light bulb and see what happens when the unit is sw...Musaeum — 08:49 PM
Philco 42-345 Restoration/Repair
I have that same set, ain't too much shortwave I like anyway.....it is a good AM DX set. PaulPaul Philco322 — 08:32 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum, Martin! Open a new thread in Philco Electronic Restoration when you begin working on your 38-7. ...GarySP — 08:28 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum! :wave: Here's the schematic for that radio from our digital library: Something to do bef...klondike98 — 08:05 PM

[-]
Who's Online
There are currently no members online.

>