My new RCA 6T-7 tombstone

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Pages (2): « Previous 1 2

Thread Closed

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode

My new RCA 6T-7 tombstone

Dan Walker
Senior Member

Posts: 377
Threads: 105
Joined: Jul 2011
City: Calgary, AB, CA

#16

02-08-2016, 02:06 PM

Warm to me is when I can do some work in the garage and not have cold hands. I guess about 60 F would be good.
It is supposed to get to get to 50F this week, but I have all my stripping stuff in the house.
I have all my Mohawk products, lacquer, stripper, shellac and touch up stuff in the basement and I don't want to take it out until it does not freeze at night.. It still freezes every night.
Ideally I like to do this sort of stuff when it is about 75F.

Living in Calgary Alberta

Find

« Next Oldest | Next Newest »

Pages (2): « Previous 1 2

Thread Closed

View a Printable Version

Users browsing this thread:

Recent Posts
Philco model 38 code 121 not receiving signal.
A DMM is good enough. One rarely has to measure indictance, but if you do, short of getting a serious LCR meter (I hav...morzh — 07:35 PM
Testing a speaker and output transformer Trutone A2-G
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now. Have better volu...murf — 03:43 PM
Philco model 38 code 121 not receiving signal.
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM
Philco model 38 code 121 not receiving signal.
I use a pair of Mastercraft brand DMMs from Canadian Tire, from what I read most of those DMMs use the same main chip re...Arran — 02:36 PM
Philco model 38 code 121 not receiving signal.
Thank you sir. Yes I feel good and also relieved because this one's been weighing on me a bit.Stormlord5500 — 11:18 AM
Philco model 38 code 121 not receiving signal.
It feels good don't it? Good luck on the rest.Paul Philco322 — 11:06 AM
Philco model 38 code 121 not receiving signal.
I've reinstalled the coil. Now IT'S ALIVE!!!!!! I fired up my TinySA on signal generator mode and set it to 1400Kc and ...Stormlord5500 — 11:01 AM
Philco model 38 code 121 not receiving signal.
Yes, Walmart, right up there with Fluke.RodB — 11:00 AM
PT 6 chassis screws size???
it certainly won't be metric! SAE threads were all that was known then. Take care, - GaryGarySP — 10:58 AM
Philco model 38 code 121 not receiving signal.
I think this thing is way more accurate than my Walmart DMM. :DStormlord5500 — 08:19 AM

Who's Online

There are currently 1313 online users. [Complete List]
» 3 Member(s) | 1310 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me