Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Suprise! Philco Mystery Dials built in Finland
#1

On doing some completely unrelated research I followed this link to this VERY long web page:
http://forum.axishistory.com/viewtopic.p...&start=225

About 40% down the page there is a description of Philco Mystery Dial sets being built under license in Finland. Icon_surprised .. Don't know if that tid-bit has appeared here since I can't seem to enter a search query here..

Now back to my real task of researching Soviet made radios of the 1950s.

Robert
#2

Surprise!

There is some misinformation in those posts. I will elaborate later. For now, however, suffice it to say that the the photo purporting to show "A typical ASA Radio Dealership of the 1930’s" is actually a photo of a Philco dealership in the USA, taken from an issue of the Philco Serviceman.

Directly below that, the photo allegedly showing "An ASA Radio Repair Workshop of the 1930’s" is actually a Philco dealer in Colombia, again, taken from Philco Serviceman.
http://philcoradio.com/phorum/showthread.php?tid=15017

--
Ron Ramirez
Ferdinand IN
#3

(11-07-2016, 12:09 PM)kd4hsh Wrote:  On doing some completely unrelated research I followed this link to this VERY long web page:
http://forum.axishistory.com/viewtopic.p...&start=225

About 40% down the page there is a description of Philco Mystery Dial sets being built under license in Finland.  Icon_surprised ..  Don't know if that tid-bit has appeared here since I can't seem to enter a search query here..

Now back to my real task of researching Soviet made radios of the 1950s.

Robert

Robert


Oh...that was you on Peter's Radiosvit site

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco Model 38-7: what caps & resistors do fail typically?
Since you stated earlier, you have a console 38-7XX.  They also had a 38-7T (table), and 38-7CS (chairside).  A very nic...GarySP — 01:18 PM
Part numbers to model cross
That I wouldn't know, but sometimes the radio document itself shows one, same as the capacitor cans' etc pinouts.morzh — 12:46 PM
Part numbers to model cross
Thank you morzh, that is exactly what I was looking for. Now , is there some where that shows pinouts for Philco power ...Jim Dutridge — 11:37 AM
Restoration of the Canadian General Electric A-87
Thanks for your help Michael. In fact, this video is only an intermediate result. Later I had to apply another tinting l...RadioSvit — 09:01 AM
Restoration of the Canadian General Electric A-87
Great job on the cabinet. PS. In the US notation, "kenotron" refers to specific type of tubes; we call re...morzh — 08:24 AM
Part numbers to model cross
This document has at least some tables of models and parts used. Example: Choke 32-7572, used in 604 radio. Search f...morzh — 08:19 AM
Restoration of the Canadian General Electric A-87
I also checked all the radio tubes on my Hickok 530 tube tester. The 5Z3 kenotron turned out to be faulty, all the other...RadioSvit — 08:02 AM
Restoration of the Canadian General Electric A-87
Well... While the varnish is drying up, I started repairing the chassis... Of course I started by replacing the pa...RadioSvit — 07:12 AM
Philco Model 38-7: what caps & resistors do fail typically?
Hello Martin, Welcome aboard our little community what great Model 38-7 Sincerely Richardradiorich — 12:30 AM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum Martin. I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM

[-]
Who's Online
There are currently no members online.

>