Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

zenith 12s568 issue
#1

Brought home another of these beauties this weekend.
Friend of mine was clearing some radios out.
Pulled the chassis, checked tubes and replaced a few weak ones, checked cadohm resistor and looked it over.
E-caps have been replaced previously.
Powers up fine and does have audio, but no reception on any band.
Tried tweeking the alignment thru the adjustment screws on the If cans.
Noticed one of the cans had no response to adjusting either of the screws.
Seems like an open coil somewhere for sure.
What would you guys suggest I try next?
I have another of these that I did a year ago, and they are super players with great sound.
I see I will be replacing some rubber wire again on this one.
Happy 4th everyone!
murf
#2

I'd ohm out the coils to see if you have an open somewhere like you suspect.  Also if it has crumbling rubber wire and some old paper caps those could also be causing problems, but I personally like to know if my coils are good before doing much else.

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"
#3

What John said.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.




Users browsing this thread:
[-]
Recent Posts
Restoration of the Canadian General Electric A-87
Well... While the varnish is drying up, I started repairing the chassis... Of course I started by replacing the pa...RadioSvit — 07:12 AM
Philco Model 38-7: what caps & resistors do fail typically?
Hello Martin, Welcome aboard our little community what great Model 38-7 Sincerely Richardradiorich — 12:30 AM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum Martin. I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM
Part numbers to model cross
Jim, We have this index put together by Dale Cook but I don't think that is quite what you are looking for. The Parts...klondike98 — 09:37 PM
Philco Model 38-7: what caps & resistors do fail typically?
Yep the dim bulb test is OK but I'd definitely replace all those electrolytics before I did it. Since those #47 conden...klondike98 — 09:18 PM
Philco 42-345 Restoration/Repair
The resistor is a 2.2 Meg, it was the last one I hadn't replaced. The broadcast is coming in after replacing it.osanders0311 — 09:09 PM
Philco 42-345 Restoration/Repair
What does the resistor measure? I think it should be 3.3 Meg. If the oscillator coil has continuity and the resistanc...RodB — 09:03 PM
Philco Model 38-7: what caps & resistors do fail typically?
Good idea to check the coils... then I'll get hold of an incadescent light bulb and see what happens when the unit is sw...Musaeum — 08:49 PM
Philco 42-345 Restoration/Repair
I have that same set, ain't too much shortwave I like anyway.....it is a good AM DX set. PaulPaul Philco322 — 08:32 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum, Martin! Open a new thread in Philco Electronic Restoration when you begin working on your 38-7. ...GarySP — 08:28 PM

[-]
Who's Online
There are currently 1254 online users. [Complete List]
» 1 Member(s) | 1253 Guest(s)
Avatar

>