Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Broadcast Bands?
#1

Does anyone broadcast anything anymore on the short wave, long wave or police bands?
#2

Broadcast band is what is commonly called "AM radio" Yes, there are many stations on that band. It runs from 550 KC to 1600 KC, and is mostly talk radio these days, but there are a few music stations too. The shortwave bands are still used and there are many stations from around the world that broadcast programs of news from their nation and their nation's point of view, local culture and music. You can find stations in the range of 5 MC to about 8 MC with ham bands just above 7 MC, more international stations between 9 MC and 10 MC, and still more between 11 MC and 12 MC. You can find listings of the frequencies and times of these broadcasts on the net.here is a link to one site  http://www.primetimeshortwave.com/  . The police band that falls between these areas, 1600 KC to 5 MC is pretty much dead for general listening. You can find the u. S. National Bureau of Standards time signal at 5.00 MC and 10.00 MC it is a good standard to check your alignment.
#3

Thanks Mike, yes I was aware of the AM broadcast. I assumed it was the band labeled "Standard Broadcast". It was the other three I wasn't sure about.
I also have another radio with the four bands on the dial, but instead of the band labeled "Police" it is labeled "Amateur". Would this be the same or more for the ham radio operator type of thing?
#4

The police band on these old set haven't been used by the police since before wwII. Nowadays it's all vhf and uhf fm. LW band is pretty useless short of a small ham band and a couple of navigational signals that are transmitted in Morse code. Bands that have Amateur markings still are ham bands and since the 80's a few more have been added.
These days there are a lot of modern devices that generate a lot of interference in the lw/mw/sw bands. Phone and laptop chargers are some of the worst offenders. They use what known as switch mode power supplies. They make buzzy noises all over the spectrum.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#5

Got it. Thank you.
#6

in the old Police band you will now find some Amateur frequencies, you can find a listing of them here, http://www.arrl.org/frequency-allocations . You will also find the amateur frequencies for bands in the longwave spectrum, and in the shortwave spectrum above the old "police band".
#7

Thanks Mike. I will search them out.
#8

Thanks for asking this question, I , too, wondered the same.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
So one last question before I finish this radio. Regarding the speaker and output transformer. I salvaged the original o...Stormlord5500 — 09:31 AM
462ron
It’s on the bottom of the homepage of our Philcoradio.com homepage! Ron462ron — 07:20 AM
Model 70 Cabinet Trim
Steve might have some trim left. Not sure he is making anything.morzh — 06:12 AM
Model 70 Cabinet Trim
Hello musar, First all welcome to the forum and yes that is true that steve stopped making trim . Sincerely Richar...radiorich — 12:13 AM
Model 70 Cabinet Trim
I have recently come into possession of a Model 70.  The trim around the base needs to be replaced.  If this were years ...musar — 12:07 AM
philcorepairbench.com - shadow-meter
Anyone know of a way to recover these files from the repair bench? Thanks. fenbach — 11:16 PM
Philco model 38 code 121 not receiving signal.
That's true. Of course If I were to get a vtvm I'd probably have to sink money in to it to get it working right. Probabl...Stormlord5500 — 08:44 PM
Philco model 38 code 121 not receiving signal.
A DMM is good enough. One rarely has to measure indictance, but if you do, short of getting a serious LCR meter (I hav...morzh — 07:35 PM
Testing a speaker and output transformer Trutone A2-G
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now. Have better volu...murf — 03:43 PM
Philco model 38 code 121 not receiving signal.
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM

[-]
Who's Online
There are currently 1006 online users. [Complete List]
» 3 Member(s) | 1003 Guest(s)
AvatarAvatarAvatar

>