[Acstriegel]

Hi there, is there a recommended source to buy a replacement cone for a Philco table top 42-350? Any idea what they cost?  Thanks for any info.

[Paul Philco322]

Sometimes a professional recone works out well and not that expensive........

This guy is a decent fellow and does fine work, reasonable last time I used him.

http://www.soundremedynj.com/

Paul

[Ron Ramirez]

Yeah, Rich Stamer at Sound Remedy is the best.

[Acstriegel]

Thanks guys, I'll get in touch and see what he says.

[sdradioman]

I recommend Nick Dorazio at thespeakershop.com in Florida.

Have had half a dozen speakers reconed/ field coils/voice coils rewound thru him and he does great work.

[Acstriegel]

Another great recommendation!  Thank you.  I heard back from Rich Stamer and he said "The only limiting factor is the voice coil, minimum size is 0.522" I.D."  I have the broken voice coil from the radio and I measured it, it's a little over 1/2 inch in diameter so it might be within Rich's requirement.  Not sure.  But great to have another source to ask.  I'm on it.  Thanks again sdradioman!