Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

M3850T Philco / Ford
#1

I just acquired a "Philco / Ford M3850T" and I am looking for a schematic.  I've tried PhilcoRadio.com and any other sources I could think of but keep coming up empty.  Sams Photofact has something but I think it's wrong.
#2

Hi and welcome,

I took a look around but didn't see much either. Seems it circa 1966 but not listing for that particular model. Bare in mind that just about all the set we discuss are from 1928-1960 and most vacuum tube. Sam's might be only source for info.
Good luck!

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#3

Thank you so much for the reply, Terry. I sincerely appreciate your time, and I'll keep digging. It may be that an old fashioned visit to my local library is in order!




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 37-116 Cabinet Repair
Hello everyone. I completely agree with Richard and Dan - in this case, without replacing the veneer, only a wax filler ...RadioSvit — 10:07 AM
Philco 37-116 Cabinet Repair
I have used Timber Mate Timber mate is a grain filler  . You can get it in different colors,so it will be close to...Dan Walker — 09:51 AM
Help with Supreme 599
The 300 ohm line adjustment is used to set the primary of the transformer to a nominal voltage for any line voltage from...DaleHCook — 09:22 AM
Philco 37-116 Cabinet Repair
I think Arran is correct about the substrate expansion. I'm going to give the colored wax a try.dconant — 08:11 AM
Philco 37-116 Cabinet Repair
Hello Guys, What I would do is get  colors of wax filler and fill in the void ! Sincerely Richardradiorich — 12:41 AM
Philco 37-116 Cabinet Repair
It looks to me like the structure under the veneer may have expanded from humidity cracking the veneer on the surface. W...Arran — 09:42 PM
Help with Supreme 599
Iam only getting 4vac out of the tranny For the 80 filament. The line rheostat Looks fine and the tranny is getting 11...daveone23 — 08:45 PM
Rogers Majestic R-646
Transformers rewind? It's very easy! If you don't have round eyes  8-) Vlad95 — 01:55 PM
Help with Supreme 599
I found a broken wire from the end og the 300 ohm line adjust to the transforner but i dont think its needed. The transf...daveone23 — 11:43 AM
Philco 38-10 Tuning Condenser
RodB I have been using pure Vaseline for a long time for thick lubrication of home radio devices. The main reason is t...Vlad95 — 10:58 AM

[-]
Who's Online
There are currently 1066 online users. [Complete List]
» 1 Member(s) | 1065 Guest(s)
Avatar

>