Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Airline 62-196
#1

Just finished an Airline 62-196 tombstone. 7 tube, 3 band radio with some neat features. All 3 bands are on the southern 180 degrees of the dial, or are from 90 degrees to 270 degrees. They are color coded and a a light switches from colored indicator to a different colored indicator in the lower center of the dial to indicate which band the radio is recieving. The top half of the dial has the relative positions for circa 1935 stations, for the most part they are opposite the freq (lower) side of the dial. WPTF Raleigh is located exactly opposite 680 KHz on the dial, which is correct. There are also "mini dials" that indicate tone and on/off/volume that are on the left and right side of the dial face. Also included is a "broad" and "sharp" selectivity switch that either allows or dis allows a wide (broad) range of audio freqs to be heard. Additionally there is a "dual" volume control feature that consists of a "normal" 500K ohm pot ganged with an additional 2500 ohm pot that reduces reciever sensitivity at low volume to cut down on noise between stations. A neat set.

http://s1194.photobucket.com/albums/aa37...=slideshow




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
Hello Stormlord, Well done on rewinding that coil it turned fairly good for your first one. Sincerely Richardradiorich — 09:12 PM
Philco model 38 code 121 not receiving signal.
Well here it is. It ain't pretty, but hopefully it'll work. I checked it with my DMM on continuity and it keeps and r...Stormlord5500 — 08:56 PM
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM

[-]
Who's Online
There are currently 829 online users. [Complete List]
» 2 Member(s) | 827 Guest(s)
AvatarAvatar

>