Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Keep the same thread, questions on 12 Caps please
#1

Ok you have seen this thread but looking for the value of the three caps on a late model 112 (47 output tubes). The three I'm looking for are the ones used in the tone control switch. Appreciate some help here. Not labeled on the schematic. Thanks for any help.
Jerry






Can anyone suggest a grill cloth that would be as close as possible to original for the above model? The one I just received has black! It looks old but doubt if it's right.
Thanks, Jerry

[Image: http://i303.photobucket.com/albums/nn129...2front.jpg]

[Image: http://i303.photobucket.com/albums/nn129...punder.jpg]

Can anyone tell me the value of caps in the three metal cans shown in the above? This is a later model 112 with the 47 output tubes. Awaiting better reading schematics from Chuck but hope to get a order in for caps.

Jerry

A friend in need is a pest!  Bill Slee ca 1970.
#2

http://www.grillecloth.com/grillcloth/gallery.php

Pattern 42 or 64 - not original but better than black.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
#3

Phlogiston Wrote:http://www.grillecloth.com/grillcloth/gallery.php

Pattern 42 or 64 - not original but better than black.
Those two patterns (42 and 64) look better in person than how they show up on-line. The actual samples don't have that red or orange tint..... at least that's how they show up on my monitor.

As our traditional sources of grille cloth dry up we may want to investigate other sources like the site Mike Koste mentions:

http://www.philcoradio.com/phorum/showth...p?tid=4038

http://www.philcoradio.com/phorum/showth...p?tid=4038

While some look like grillecloth.com patterns they might have a few different styles.

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"
#4

The original pattern that was used in these sets was a stylized "P" that repeated itself, right side up and upside down, over the entire cloth.

This pattern was never reproduced.

I think S-G431F from Antique Electronics Supply would be a better choice, but that's just one man's opinion. This pattern is no longer available from Radio Grille Cloth Headquarters. This is a cross between the old patterns 1 and 2, a mixture of whiskey and copper colors.

--
Ron Ramirez
Ferdinand IN
#5

Thank you all for your suggestions. I will do a little looking. Jerry

A friend in need is a pest!  Bill Slee ca 1970.




Users browsing this thread:
[-]
Recent Posts
Restoration of the Canadian General Electric A-87
Well... The console body has been restored, while the varnish dries reliably I started to paint the chassis ...RadioSvit — 07:12 AM
Philco Model 38-7: what caps & resistors do fail typically?
Hello Martin, Welcome aboard our little community what great Model 38-7 Sincerely Richardradiorich — 12:30 AM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum Martin. I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM
Part numbers to model cross
Jim, We have this index put together by Dale Cook but I don't think that is quite what you are looking for. The Parts...klondike98 — 09:37 PM
Philco Model 38-7: what caps & resistors do fail typically?
Yep the dim bulb test is OK but I'd definitely replace all those electrolytics before I did it. Since those #47 conden...klondike98 — 09:18 PM
Philco 42-345 Restoration/Repair
The resistor is a 2.2 Meg, it was the last one I hadn't replaced. The broadcast is coming in after replacing it.osanders0311 — 09:09 PM
Philco 42-345 Restoration/Repair
What does the resistor measure? I think it should be 3.3 Meg. If the oscillator coil has continuity and the resistanc...RodB — 09:03 PM
Philco Model 38-7: what caps & resistors do fail typically?
Good idea to check the coils... then I'll get hold of an incadescent light bulb and see what happens when the unit is sw...Musaeum — 08:49 PM
Philco 42-345 Restoration/Repair
I have that same set, ain't too much shortwave I like anyway.....it is a good AM DX set. PaulPaul Philco322 — 08:32 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum, Martin! Open a new thread in Philco Electronic Restoration when you begin working on your 38-7. ...GarySP — 08:28 PM

[-]
Who's Online
There are currently 820 online users. [Complete List]
» 3 Member(s) | 817 Guest(s)
AvatarAvatarAvatar

>