Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Dragged in another postwar Zenith.
#1

A co-worker and friend of mine talked to me a few days ago and wondered if I wanted a Zenith conole radio he had gotten cheap at a junk auction. Said he had been listening to FM on it without much issue. I went to visit him today and found it to be a decent little radio-phono console from the early 50's. Has an 8H20 chassis in it with the variable speed phonograph that I find to be neat. A little cash later and it was coming home. Other than the odd dial light being burnt out and a dirty band switch, it seemed to work fine on the radio. I pulled the chassis to clean up the switches and get the worst of the dirt blown off, only to find the one oil ringer cap near the power switch was blown clear in half! So, it will be getting recapped in the future. Kind of a shame as it was working rather well in spite of the bad cap. Cabinet is good except the top. Back top veneer is messed up. It should be worth a few extra dollars to put the insides right. I'll get some pictures of it once it is back together.

No matter where you go, there you are.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
That's true. Of course If I were to get a vtvm I'd probably have to sink money in to it to get it working right. Probabl...Stormlord5500 — 08:44 PM
Philco model 38 code 121 not receiving signal.
A DMM is good enough. One rarely has to measure indictance, but if you do, short of getting a serious LCR meter (I hav...morzh — 07:35 PM
Testing a speaker and output transformer Trutone A2-G
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now. Have better volu...murf — 03:43 PM
Philco model 38 code 121 not receiving signal.
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM
Philco model 38 code 121 not receiving signal.
I use a pair of Mastercraft brand DMMs from Canadian Tire, from what I read most of those DMMs use the same main chip re...Arran — 02:36 PM
Philco model 38 code 121 not receiving signal.
Thank you sir. Yes I feel good and also relieved because this one's been weighing on me a bit.Stormlord5500 — 11:18 AM
Philco model 38 code 121 not receiving signal.
It feels good don't it? Good luck on the rest.Paul Philco322 — 11:06 AM
Philco model 38 code 121 not receiving signal.
I've reinstalled the coil. Now IT'S ALIVE!!!!!! I fired up my TinySA on signal generator mode and set it to 1400Kc and ...Stormlord5500 — 11:01 AM
Philco model 38 code 121 not receiving signal.
Yes, Walmart, right up there with Fluke.RodB — 11:00 AM
PT 6 chassis screws size???
it certainly won't be metric! SAE threads were all that was known then. Take care, - GaryGarySP — 10:58 AM

[-]
Who's Online
There are currently 1871 online users. [Complete List]
» 1 Member(s) | 1870 Guest(s)
Avatar

>