Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco rack (training aid)
#1

Hi,

During my military training (mid sixties) to become a radar technician in one of the practical labs a training aid was used. This equipment was referred to, as far as i remember, as the ‘Philco rack’. It comprised of a couple of about 3 by 1,5 feet metal racks in which all kind of units could be fitted. These units were all kind of basic electronic circuits (amplifier, oscillators, even thyristor circuits and wave guide parts). The resistors and capacitors could easily be replaced to perform all kind of measurements or experiments.

Now I tried to find some information on this equipment on the internet but was not successful. However I found this forum. And given the name of the rack I ask the question here. Can anybody give me or refer me to information on the internet of this training aid.
BTW I found a picture of some military in training with in the background the equipment I am talking about. This picture is attached.

Butch


Attached Files Image(s)
   
#2

Wow. Did the base barber shop close down for 6 months?

It's not how bad you mess up, it's how well you can recover.
#3

They allow those hairdos in the US Army?




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
PT 6 chassis screws size???
Have this done except for missing chassis screws. It looks like 1 inch 6/32 sheet metal screw may work but can anyone s...bridkarl — 10:32 PM
Philco model 38 code 121 not receiving signal.
Hello Stormlord, Well done on rewinding that coil it turned fairly good for your first one. Sincerely Richardradiorich — 09:12 PM
Philco model 38 code 121 not receiving signal.
Well here it is. It ain't pretty, but hopefully it'll work. I checked it with my DMM on continuity and it keeps and r...Stormlord5500 — 08:56 PM
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM

[-]
Who's Online
There are currently 1001 online users. [Complete List]
» 1 Member(s) | 1000 Guest(s)
Avatar

>