Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Another example of Baby Strat Z restoration
#1

http://williamsport.craigslist.org/atq/4253186803.html

(He is not selling it - it is an example of what he does).

This guy is in Unityville PA.

Very nice job.
Or at least I think so.
#2

Too bad it is dull and not toned right and has the wrong grill cloth, otherwise ok. Then again I didn't see the chassis.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
#3

I was thinking the same Russ, I can't understand why people insist on refinishing old radio cabinets in a satin or matte finish, it may be pleasing to some eyes but it is still wrong. I also noticed the lack of shading, though it isn't the worst I've seen for that by a long shot. Even a Baby Strat is valuable enough to deserve a factory original refinish.
My problem with this is even now some people think that finishes like this are original, I've seen many fleabay and craigslist listings describing mediocre matte refinish jobs as such. It's not really a surprise since in many cases it is just about impossible to find a photo of a given model online whose finish has not been tampered with.
Regards
Arran




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Model 70 Cabinet Trim
Hello musar, First all welcome to the forum and yes that is true that steve stopped making trim . Sincerely Richar...radiorich — 12:13 AM
Model 70 Cabinet Trim
I have recently come into possession of a Model 70.  The trim around the base needs to be replaced.  If this were years ...musar — 12:07 AM
philcorepairbench.com - shadow-meter
Anyone know of a way to recover these files from the repair bench? Thanks. fenbach — 11:16 PM
Philco model 38 code 121 not receiving signal.
That's true. Of course If I were to get a vtvm I'd probably have to sink money in to it to get it working right. Probabl...Stormlord5500 — 08:44 PM
Philco model 38 code 121 not receiving signal.
A DMM is good enough. One rarely has to measure indictance, but if you do, short of getting a serious LCR meter (I hav...morzh — 07:35 PM
Testing a speaker and output transformer Trutone A2-G
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now. Have better volu...murf — 03:43 PM
Philco model 38 code 121 not receiving signal.
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM
Philco model 38 code 121 not receiving signal.
I use a pair of Mastercraft brand DMMs from Canadian Tire, from what I read most of those DMMs use the same main chip re...Arran — 02:36 PM
Philco model 38 code 121 not receiving signal.
Thank you sir. Yes I feel good and also relieved because this one's been weighing on me a bit.Stormlord5500 — 11:18 AM
Philco model 38 code 121 not receiving signal.
It feels good don't it? Good luck on the rest.Paul Philco322 — 11:06 AM

[-]
Who's Online
There are currently no members online.

>