Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Phonographs.
#1

Now that I have one, I wonder what was the last year Philco quit making its own changers and switched over to vendors like V-M? Just curious as I also wonder how hard it would be to find a nice Philco Hi-Fi with one of these changers in it. (M24, M26, M28 ).

No matter where you go, there you are.
#2

"D" Line (1956) was the last year Philco used its own changer across the entire line.

"E" Line (1957) was a cross over year. The Philco M-38 was used in low end portables and the M-39 WebCor Micro-Mix changer was introduced.

("F" line) 1958 introduced the VM in the low end and continued the Micro-Mix for the high end. Eventually the Glaser-Steers was phased in for the high end. The GS was clearly the best changer Philco ever used.

The original Philco changer was mono only and never available in stereo.

Don
#3

Thanks for information! I have a Philco hi-fi with the VM changer, but thought I might keep an eye out for one with the Philco changer as well. Nothing against the VM, I like that brand a lot.

No matter where you go, there you are.
#4

For what it's worth, I believe the FIRST one they made themselves was the one in the '42 combo with the Beam-O-Light and the bakelite arm.




Users browsing this thread:
[-]
Recent Posts
Restoration of the Canadian General Electric A-87
Well... The console body has been restored, while the varnish dries reliably I started to paint the chassis ...RadioSvit — 07:12 AM
Philco Model 38-7: what caps & resistors do fail typically?
Hello Martin, Welcome aboard our little community what great Model 38-7 Sincerely Richardradiorich — 12:30 AM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum Martin. I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM
Part numbers to model cross
Jim, We have this index put together by Dale Cook but I don't think that is quite what you are looking for. The Parts...klondike98 — 09:37 PM
Philco Model 38-7: what caps & resistors do fail typically?
Yep the dim bulb test is OK but I'd definitely replace all those electrolytics before I did it. Since those #47 conden...klondike98 — 09:18 PM
Philco 42-345 Restoration/Repair
The resistor is a 2.2 Meg, it was the last one I hadn't replaced. The broadcast is coming in after replacing it.osanders0311 — 09:09 PM
Philco 42-345 Restoration/Repair
What does the resistor measure? I think it should be 3.3 Meg. If the oscillator coil has continuity and the resistanc...RodB — 09:03 PM
Philco Model 38-7: what caps & resistors do fail typically?
Good idea to check the coils... then I'll get hold of an incadescent light bulb and see what happens when the unit is sw...Musaeum — 08:49 PM
Philco 42-345 Restoration/Repair
I have that same set, ain't too much shortwave I like anyway.....it is a good AM DX set. PaulPaul Philco322 — 08:32 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum, Martin! Open a new thread in Philco Electronic Restoration when you begin working on your 38-7. ...GarySP — 08:28 PM

[-]
Who's Online
There are currently 822 online users. [Complete List]
» 2 Member(s) | 820 Guest(s)
AvatarAvatar

>