Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12, 2025) x

Thread Closed

philco 84 Ecap lead placement
#1

I am re-stuffing the can in my 84 and I am lost on where to put the leads. I replace an 8uf and a 4uf but I dont know what wires connect to them.

Do the 2 positives get twisted together and go to the rectifier?

Or do the 2 grounds get twisted?

Not sure of the schematic since I cant read them well.
Schematics here:
http://www.nostalgiaair.org/PagesByModel...013875.pdf

Any help on this is appreciated
Kirk

Times I have been electrocuted in 2021
As of 1/01/2021
AC: 4 DC: 1
Last year: 6
#2

Kirk,

The top-side leads definitely do NOT get tied together. The 8 uF goes to the rectifier. The 4 uf goes to the top side side of cap 32.

The negative leads are electrically connected. Don't know if they need to be twisted together or not, whichever is easier. These leads go to the center tap of the power transformer and to Cap 28 and resistor 30.

Good luck.
Jon
#3

The pos go to your speaker (thats where all leads tie together on my 84)look at the sch at the x connections at white and green/white. When there is a dot on the sch that means that the wires are connected.
#4

DONE!
I have a working radio with complete recapping and no off value resistors!


THanks guys Icon_mrgreenIcon_mrgreen

Times I have been electrocuted in 2021
As of 1/01/2021
AC: 4 DC: 1
Last year: 6




Users browsing this thread:
[-]
Recent Posts
54C Complete Teardown/Rebuild
Hello Roy, here is this one sincerely Richardradiorich — 12:45 AM
54C Complete Teardown/Rebuild
Richard, Had grabbed it already but thank you just the same.  I find myself wanting to find some way to block out the...glyphmon — 12:03 AM
54C Complete Teardown/Rebuild
Hello roy, here is a link to the schematic . Sincerely Richardradiorich — 11:54 PM
54C Complete Teardown/Rebuild
Richard, The Silvertone 2014 also is a transformerless set, so I am incorporating a 1:1 600 ohm audio isolation transfo...glyphmon — 11:37 PM
Preliminary work on wife's Silvertone 2014
Did an alignment today which was interesting.  IF alignment went great, almost all was already spot-on.  Adjusting on th...glyphmon — 11:35 PM
54C Complete Teardown/Rebuild
The main problem with adding a Bluetooth input is that this set lacks a traditional power transformer to isolate it from...radiorich — 11:19 PM
54C Cabinet Refinish
I started stripping this cabinet before it got super chilly out because I knew I wasn't going to be able to work on ...glyphmon — 11:18 PM
54C Complete Teardown/Rebuild
While I'm waiting to wrap up the final steps on my wife's Silvertone 2014, I started disassembly on the next project.  O...glyphmon — 11:07 PM
Preliminary work on wife's Silvertone 2014
Hello roy, that great news glad it worked out for you !! Sincerely Richardradiorich — 10:50 PM
Preliminary work on wife's Silvertone 2014
Safety caps arrived today.  Soldered one in and had a successful first power-up.  No magic smoke escaped and it tunes in...glyphmon — 09:53 PM

[-]
Who's Online
There are currently no members online.

>