Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 42-365
#1

I'm a new to the forum ...... experienced in electronics, but all post tube era. I acquired a 42-365 when moving my parents from their home to assisted living. The cabinet is in very good condition ...... but would look nicer with a restoration. There is a loud constant hum ( independent of volume) which Ron tells me is likely the electrolytics. I don't see much discussion on this model. Are there a lot of these around? Is it an uncommon model?
#2

http://www.philcoradio.com/gallery/1942a.htm

Not a real common set...but not a desirable one, either, from a collectibility standpoint. I have one like yours, either a 42-365 or 360, don't really remember right now. It was given to me by a good friend...I do not plan to restore it, but will use it for parts. Its cabinet is pretty much shot.

Do replace those electrolytics, and ALL paper capacitors as well. The old rubber insulation on the wiring will also have to be addressed.

Good luck, and enjoy!

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Part numbers to model cross
Thank you morzh, that is exactly what I was looking for. Now , is there some where that shows pinouts for Philco power ...Jim Dutridge — 11:37 AM
Restoration of the Canadian General Electric A-87
Thanks for your help Michael. In fact, this video is only an intermediate result. Later I had to apply another tinting l...RadioSvit — 09:01 AM
Restoration of the Canadian General Electric A-87
Great job on the cabinet. PS. In the US notation, "kenotron" refers to specific type of tubes; we call re...morzh — 08:24 AM
Part numbers to model cross
This document has at least some tables of models and parts used. Example: Choke 32-7572, used in 604 radio. Search f...morzh — 08:19 AM
Restoration of the Canadian General Electric A-87
I also checked all the radio tubes on my Hickok 530 tube tester. The 5Z3 kenotron turned out to be faulty, all the other...RadioSvit — 08:02 AM
Restoration of the Canadian General Electric A-87
Well... While the varnish is drying up, I started repairing the chassis... Of course I started by replacing the pa...RadioSvit — 07:12 AM
Philco Model 38-7: what caps & resistors do fail typically?
Hello Martin, Welcome aboard our little community what great Model 38-7 Sincerely Richardradiorich — 12:30 AM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum Martin. I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM
Part numbers to model cross
Jim, We have this index put together by Dale Cook but I don't think that is quite what you are looking for. The Parts...klondike98 — 09:37 PM
Philco Model 38-7: what caps & resistors do fail typically?
Yep the dim bulb test is OK but I'd definitely replace all those electrolytics before I did it. Since those #47 conden...klondike98 — 09:18 PM

[-]
Who's Online
There are currently 1271 online users. [Complete List]
» 1 Member(s) | 1270 Guest(s)
Avatar

>