Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

42-380 recap
#1

Does anyone have a complete list of new capacitors needed to recap a 42-380? Or if there is a specific kit?
#2

There's a schematic with caps listed on Nostalgiaair and the the Audiophool site has a clearer copy of the service bulletin here: http://www.audiophool.com/Philco.html but at the moment that site seems to be down. Hopefully it comes back up soon. Usually only the electrolytic and paper caps need replacing. Check resistors as well, the sometimes need replacement. The wiring in the '39-'49 sets has rubber insulation that often is failing. See: http://www.philcoradio.com/phorum/showth...?tid=14959 for tips/info.
#3

I wuddn't say there's a kit as much as making a list of electrolytic and paper/wax caps from either the parts list or looking at each cap for it's value. And then marking them off on the schematic. Buy small quantities of components needed and save the overage for the next job. (there will be a next job, right?)




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
So one last question before I finish this radio. Regarding the speaker and output transformer. I salvaged the original o...Stormlord5500 — 09:31 AM
462ron
It’s on the bottom of the homepage of our Philcoradio.com homepage! Ron462ron — 07:20 AM
Model 70 Cabinet Trim
Steve might have some trim left. Not sure he is making anything.morzh — 06:12 AM
Model 70 Cabinet Trim
Hello musar, First all welcome to the forum and yes that is true that steve stopped making trim . Sincerely Richar...radiorich — 12:13 AM
Model 70 Cabinet Trim
I have recently come into possession of a Model 70.  The trim around the base needs to be replaced.  If this were years ...musar — 12:07 AM
philcorepairbench.com - shadow-meter
Anyone know of a way to recover these files from the repair bench? Thanks. fenbach — 11:16 PM
Philco model 38 code 121 not receiving signal.
That's true. Of course If I were to get a vtvm I'd probably have to sink money in to it to get it working right. Probabl...Stormlord5500 — 08:44 PM
Philco model 38 code 121 not receiving signal.
A DMM is good enough. One rarely has to measure indictance, but if you do, short of getting a serious LCR meter (I hav...morzh — 07:35 PM
Testing a speaker and output transformer Trutone A2-G
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now. Have better volu...murf — 03:43 PM
Philco model 38 code 121 not receiving signal.
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM

[-]
Who's Online
There are currently 422 online users. [Complete List]
» 1 Member(s) | 421 Guest(s)
Avatar

>