1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
49-506 (49-500) Loop Antenna
SRv2
Junior Member
**
Posts: 27
Threads: 5
Joined: Mar 2024
City: BERTHOUD State, Province, Country: CO
#1

05-03-2024, 07:47 PM
Hi all,
Has anyone wound a new loop antenna for this model, or does anyone know a source where a loop antenna can be purchased?  I am working on a 49-506 that is missing the original loop antenna.  I have a 49-500 (same chassis) that has the loop antenna, so I could try to figure out the number of winds, wire size, etc.  
To be honest, I have never wound a loop antenna, but heck there are so many things I haven't done in life, and so many things I have done that I long ago forgot that I did - so I figured why not!  
Any tips from my phorum-phriends?  Do's, don'ts, wire type, etc?
The 49-506 is going to my daughter for her birthday, she loves the wedge design.  I'll probably work on the 49-500 in parallel and do a 2-for-1 special while my head is into it. 
Thanks,
George


Attached Files Image(s)
       
George - Berthoud, Colorado.  Learned tube receiver repair and troubleshooting in the Navy way back when, came back around to it as an old guy.  Re-learning all I can.  Doing my part to restore a few of these old gems.
(This post was last modified: 05-03-2024, 07:51 PM by SRv2.)
Find
« Next Oldest | Next Newest »




Users browsing this thread:
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2157 online users. [Complete List]
» 1 Member(s) | 2156 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration