Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 1935 66B
#1

Hello, I'm VERY new to this, I'm glad I found a community that can help (if anyone can).  

I have a 1935 66B that belonged to my Grandfather or perhaps my Great Grandmother.
It needs a lot of TLC, but it seems to work. (Yes, I plugged it in before I knew I shouldn't, luckily I dodged a bullet.)  
The dial light still lights and sound came out of the speaker.

A long time ago I used to work on basic electronics, so I'm going to give it a go and see if I can restore it. 

The first thing I want to do is take the chassis out of the box to give it a good cleaning.  Is there a right way (or a wrong way) to take it apart?

VR
Larry


Attached Files Image(s)
       
#2

Welcome to the Phorum, Larry! You've come to the right place for help with your radio! For starters, there is a schematic and parts list with data in our library.
https://philcoradio.com/library/index.ph...ams-vol-1/
Take care and BE HEALTHY! Gary

"Don't pity the dead, pity the living, above all, those living without love."
Professor Albus Dumbledore
Gary - Westland Michigan
#3

There is a lot of good info on 66, and also lots of it on 60, which is very close.
Actually, some time this week I will start my own restoration of the model 60MB, from the previous year (1934) I bought at Kutztown from Wilbur last May, which uses the same case.
So, we could compare notes.
Also, there is my thread of 66S from 1935, from a few years ago.
https://philcoradio.com/phorum/showthrea...ghlight=66
Many other folks worked with 66 and placed their threads here.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#4

From what I have heard looks are somewhat deceiving, whilst the model 60MB (M stands for modern as opposed to the 60B without the M which is a cathedral model) and the 66B cabinets appear to be the same they are not quite. The 60MB has a mahogany like veneer on the front panel, and also does on the top and sides, however Philco cut corners on the 66B by using cheaper veneer on the sides and by using a dark shading lacquer over it like they did on many of their tombstone cabinets. 
Regards
Arran
#5

The model 60 vs 66 may look the same from the top and fitment the same but underneath it's a different animal.

https://philcoradio.com/library/download...%20197.pdf

Back when it was new you could hear the goings on over in Europe in those troubled times not so much w/the 60.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2150 online users. [Complete List]
» 1 Member(s) | 2149 Guest(s)
Avatar

>