1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
Philco 60 Squealing
dconant
Member
***
Posts: 243
Threads: 37
Joined: Jun 2022
City: Marion State, Province, Country: NY
#16

12-02-2024, 09:39 AM
I have been playing the radio for a while now and doing well. Turned it on today and all I got was a whole lot of noise. Took a look at the back to see if the antenna fell off and noticed the 42 tube glowing bright blue filling the whole bulb. Man what a site. Quickly turned it off. Playing well again with a replacement. Put the tube in the tester and saw a blue glow in the plates when I pushed the test button but no where near the brightness I saw in the radio. The tester did not show shorts. Guess I'll put that tube in the junk pile. Wonder what would have happened if it did that while playing and I was not in the room?
Find
RodB
Phorum Expert
*****
Posts: 1,131
Threads: 46
Joined: Feb 2015
City: Roseville, MN
#17

12-02-2024, 10:54 AM
You would probably be replacing the OPT.
Find
morzh
Odobenus rosmarus
******
Posts: 16,507
Threads: 572
Joined: Oct 2011
City: Jackson State, Province, Country: NJ
#18

12-02-2024, 12:01 PM
If the noise is still there, the OPT might just be OK. Or so we hope.
People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
Find
dconant
Member
***
Posts: 243
Threads: 37
Joined: Jun 2022
City: Marion State, Province, Country: NY
#19

12-03-2024, 08:54 AM
Radio is playing right now and sounding good.
Find
« Next Oldest | Next Newest »




Users browsing this thread:
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2144 online users. [Complete List]
» 2 Member(s) | 2142 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration