Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

41-295 REFINISHING
#1

I'm going to refinish my 41-295 , but before I start to strip it, does anyone know if Philco cabinets used the "PHOTO FINISH" like Zenith did ? ,It looks like they didn't but not 100% sure Icon_confused:
#2

Hi Bill,
I don't beleive that set had Photo finish. Posting a picture of the area you think is PP we should be able to tell for sure.
Another way is to take a high power magnifier and look for the 'dots' that are usually seen on the PP areas.

I have a set in the basement I think is the same (I can't turn it right now around to check) But it does have inlaid wood strips in the front side pieces, and below the dial escutcheon.

There is a picture of a cabinet under restoration, and I did not see anything that looked like PP on that cabinet.
Philco did use photo finish on many sets, so it is best to check first.

Gary.
#3

THANK YOU , Ihave so Zeniths with the photo finish ,what can be done for them? ,BILL
#4

Here's a link from Ron's site about photo finishes. Hope it helps.

http://www.philcoradio.com/schooley/index.htm

Bill

Sent from my Pentium II on the AT&T Dial Network




Users browsing this thread:
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2159 online users. [Complete List]
» 1 Member(s) | 2158 Guest(s)
Avatar

>