Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 38-9
#1

I was just given this farm radio console(thanks Lou!) and have a few questions.
What size and type speaker does it take?
What type of batteries are needed?
thanks
Chris
#2

38-9 is an AC operated model. Are you sure it isn't a 38-38? Or perhaps 38-39 (which operates on a 6 volt storage battery)?

--
Ron Ramirez
Ferdinand IN
#3

Ron,
Will have to double check when I get home. I probably wrote the number down wrong.
thanks
Chris
#4

Ron,
It was a 38-38 chassis in a 38-9 cabinet. any idea on how to make a battery supply for this?
thanks
chris
#5

I'm building them at the present time for someone.

See my post in the electronic restoration section.
#6

Batterymaker,

When I finish the restoration I would be interested in buying one for mine. Please e-mail details on the cost etc. tuberadiophile at aol. com
thanks
Chris
#7

Bear in mind, you'll need two batteries, a BC pack and an A battery. What do your A battery leads terminate into, a two-pin plug or large alligator clips?
#8

Batterymaker,
There are just two bare wires for the A battery labelled A+ and A-. I also have a bunch of other battery sets that I would be interested in buying battery packs. Please e-mail me at tuberadiophile at aol dot com.
thanks
Chris




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
PT 6 chassis screws size???
Hello bridKarl, that sounds right or maybe 8/32 . Sincerely Richardradiorich — 01:00 AM
PT 6 chassis screws size???
Have this done except for missing chassis screws. It looks like 1 inch 6/32 sheet metal screw may work but can anyone s...bridkarl — 10:32 PM
Philco model 38 code 121 not receiving signal.
Hello Stormlord, Well done on rewinding that coil it turned fairly good for your first one. Sincerely Richardradiorich — 09:12 PM
Philco model 38 code 121 not receiving signal.
Well here it is. It ain't pretty, but hopefully it'll work. I checked it with my DMM on continuity and it keeps and r...Stormlord5500 — 08:56 PM
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM

[-]
Who's Online
There are currently 718 online users. [Complete List]
» 1 Member(s) | 717 Guest(s)
Avatar

>