Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Schematic for a 14B - Never mind
#1

Does anybody have a clear schematic for a 14B?

It's done.

Thanks
#2

I'll bet Chuck does. I need to get one too. The one on NA really bad. From the looks of it it ought to be a great playing set. One rf amp, two if amps, and three stages of audio... Plus a shadowgraph. I've got the 14 modern version.
Terry
#3

I'm about 3/4 of the way through this one now. by the time I find a ledgable schematic, I won't need it. I'll let you know in the morning how well it works.

Interesting that a lot of the dogbone resistors in this one seem to have drifted down rather than up, or they were lower to start with and did not drift (much).

Yes, a 42 driving 2 more in PP. Should be loud, anyway.
#4

Yes, Phlogiston, I have an original Model 14 Service Bulletin No. 176, in my archives,
and all published Production Change Notes from Philco. Shadow Meter info as well.

Regards,
Chuck
#5

Thanks guys, but it is all done, just takes a couple of hrs longer without a good schematic. It is hard to tell which contacts are used in the Bakelite caps without one.

It is a very nice radio. Picked up lots of stations with only a 18" antenna.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
462ron
It’s on the bottom of the homepage of our Philcoradio.com homepage! Ron462ron — 07:20 AM
Model 70 Cabinet Trim
Steve might have some trim left. Not sure he is making anything.morzh — 06:12 AM
Model 70 Cabinet Trim
Hello musar, First all welcome to the forum and yes that is true that steve stopped making trim . Sincerely Richar...radiorich — 12:13 AM
Model 70 Cabinet Trim
I have recently come into possession of a Model 70.  The trim around the base needs to be replaced.  If this were years ...musar — 12:07 AM
philcorepairbench.com - shadow-meter
Anyone know of a way to recover these files from the repair bench? Thanks. fenbach — 11:16 PM
Philco model 38 code 121 not receiving signal.
That's true. Of course If I were to get a vtvm I'd probably have to sink money in to it to get it working right. Probabl...Stormlord5500 — 08:44 PM
Philco model 38 code 121 not receiving signal.
A DMM is good enough. One rarely has to measure indictance, but if you do, short of getting a serious LCR meter (I hav...morzh — 07:35 PM
Testing a speaker and output transformer Trutone A2-G
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now. Have better volu...murf — 03:43 PM
Philco model 38 code 121 not receiving signal.
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM
Philco model 38 code 121 not receiving signal.
I use a pair of Mastercraft brand DMMs from Canadian Tire, from what I read most of those DMMs use the same main chip re...Arran — 02:36 PM

[-]
Who's Online
There are currently 238 online users. [Complete List]
» 1 Member(s) | 237 Guest(s)
Avatar

>