Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Just acquired Philco 70
#1

I just picked up a model 70. Date on bottom of the cabinet says "Aug '31".

This is my first radio like this. It has been re-capped already I found out after taking out the chassis.

One bad tube (47 output). Has 24's not 24A's. All tubes are globe tubes, look to be pretty original, most are Philco tubes.

Cabinet in pretty good shape. I'll post pictures soon.

I did notice the tuning cap rubber grommets are shot, will replace with repros.

I did power it up on the variac, got sound, something is intermittent though, have to trace that down.

Any words of wisdom on these radios?

One more for the collection!
#2

1. Check the re-cap. Never trust anyone unless you know the person and the reputation.
2. Check the resistors.
3. Check the tubes.
4. Inspect the wiring etc.
5. See if the tone control has been re-stuffed and re-wired.
6. Power up, measure voltages.
7. If works, align.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
PT 6 chassis screws size???
Have this done except for missing chassis screws. It looks like 1 inch 6/32 sheet metal screw may work but can anyone s...bridkarl — 10:32 PM
Philco model 38 code 121 not receiving signal.
Hello Stormlord, Well done on rewinding that coil it turned fairly good for your first one. Sincerely Richardradiorich — 09:12 PM
Philco model 38 code 121 not receiving signal.
Well here it is. It ain't pretty, but hopefully it'll work. I checked it with my DMM on continuity and it keeps and r...Stormlord5500 — 08:56 PM
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM

[-]
Who's Online
There are currently 944 online users. [Complete List]
» 2 Member(s) | 942 Guest(s)
AvatarAvatar

>