Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco ventilator
#16

looking good


Attached Files Image(s)
   
#17

red lacquer finish .


Attached Files Image(s)
   
#18

new bushings and felt oilers and rivets .


Attached Files Image(s)
   
#19

the rubber mounts were suppose to be the same size on both ends but one cap end was a good bit smaller ..an old leather belt solved the problem .


Attached Files Image(s)
   
#20

new head wires and drummed sanded the stator with 220 .


Attached Files Image(s)
   
#21

ready to go back into the box .


Attached Files Image(s)
   
#22

It's up to you of course but I think that some medium walnut, dye based, toner would even out the lighter walnut veneered portions of the cabinet. Nice work on the motor repairs by the way, and fixing the broken grill bars in the front.
Regards
Arran
#23

http://youtu.be/UnOULsnYlmQ
#24

......


Attached Files Image(s)
   




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
So one last question before I finish this radio. Regarding the speaker and output transformer. I salvaged the original o...Stormlord5500 — 09:31 AM
462ron
It’s on the bottom of the homepage of our Philcoradio.com homepage! Ron462ron — 07:20 AM
Model 70 Cabinet Trim
Steve might have some trim left. Not sure he is making anything.morzh — 06:12 AM
Model 70 Cabinet Trim
Hello musar, First all welcome to the forum and yes that is true that steve stopped making trim . Sincerely Richar...radiorich — 12:13 AM
Model 70 Cabinet Trim
I have recently come into possession of a Model 70.  The trim around the base needs to be replaced.  If this were years ...musar — 12:07 AM
philcorepairbench.com - shadow-meter
Anyone know of a way to recover these files from the repair bench? Thanks. fenbach — 11:16 PM
Philco model 38 code 121 not receiving signal.
That's true. Of course If I were to get a vtvm I'd probably have to sink money in to it to get it working right. Probabl...Stormlord5500 — 08:44 PM
Philco model 38 code 121 not receiving signal.
A DMM is good enough. One rarely has to measure indictance, but if you do, short of getting a serious LCR meter (I hav...morzh — 07:35 PM
Testing a speaker and output transformer Trutone A2-G
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now. Have better volu...murf — 03:43 PM
Philco model 38 code 121 not receiving signal.
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM

[-]
Who's Online
There are currently 397 online users. [Complete List]
» 1 Member(s) | 396 Guest(s)
Avatar

>