Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Problem with Philco 37-61
#1

Hello, and please bare with me because I'm a newbie to repairing radios. I've been reading every book I can find on the subject.
I recently puchased a 37-61, and I found the 5Y4G rectifier tube to be bad, and the 6F6G Output tube tested as having a shorted cathode, on my recently puchased tube tester. I replaced the tubes, and the radio now plays and receives several stations. When It first warms up, you can turn the volume control up and it sounds OK, but after it's been on a minute or two, it still sounds ok at low volume, but the more you turn it up, the more distorted the sound becomes. Where should I look for a problem. The only test equipment I have so far is the tube tester, and a volt meter, so I'm sort of limited. Thanks in advance for any input.
Glenn
#2

Has the radio been recapped? You really should do that, you know. Icon_wink

If not, try replacing the cap that goes to the grid of the 6F6.
#3

Thanks for your input, Exray. I'll try that one cap first.
Glenn




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
So one last question before I finish this radio. Regarding the speaker and output transformer. I salvaged the original o...Stormlord5500 — 09:31 AM
462ron
It’s on the bottom of the homepage of our Philcoradio.com homepage! Ron462ron — 07:20 AM
Model 70 Cabinet Trim
Steve might have some trim left. Not sure he is making anything.morzh — 06:12 AM
Model 70 Cabinet Trim
Hello musar, First all welcome to the forum and yes that is true that steve stopped making trim . Sincerely Richar...radiorich — 12:13 AM
Model 70 Cabinet Trim
I have recently come into possession of a Model 70.  The trim around the base needs to be replaced.  If this were years ...musar — 12:07 AM
philcorepairbench.com - shadow-meter
Anyone know of a way to recover these files from the repair bench? Thanks. fenbach — 11:16 PM
Philco model 38 code 121 not receiving signal.
That's true. Of course If I were to get a vtvm I'd probably have to sink money in to it to get it working right. Probabl...Stormlord5500 — 08:44 PM
Philco model 38 code 121 not receiving signal.
A DMM is good enough. One rarely has to measure indictance, but if you do, short of getting a serious LCR meter (I hav...morzh — 07:35 PM
Testing a speaker and output transformer Trutone A2-G
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now. Have better volu...murf — 03:43 PM
Philco model 38 code 121 not receiving signal.
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM

[-]
Who's Online
There are currently 419 online users. [Complete List]
» 1 Member(s) | 418 Guest(s)
Avatar

>