Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

The Problem with Zenith 5516 Schematics
#1

I posted part 1 on this parts-change problem a while ago:

https://www.russoldradios.com/blog/zenit...16-chassis

Now here is part 2. Of significance is the comparative/corrected schematic and parts list for the later 1k FC. 

These used to frustrate me. There are a lot of them. Early on I just decided to replace what looked like FACTORY parts with the same value even if different from the schematic. Problem arises when you got one that had already befuddled the previous repair guy. The parts could be - anything.... Anyway, this should resolve the differences in the 1K FC and the 2.125k FC units.

Also has a picture of the Zenith 6-SX-127 - - - yeah, look that one up Icon_lol

https://www.russoldradios.com/blog/zenit...-part-deux

Russ

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/




Users browsing this thread:
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2139 online users. [Complete List]
» 2 Member(s) | 2137 Guest(s)
AvatarAvatar

>