Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

#1

Does anyone know if you can still get theses. And some of the color codes are gone . What do you look for to order replacements .
I seen the site at the repair bench . Does Chuck sell them. Icon_rolleyes
Thanks Kent.
#2

Hi Kent

No, Chuck does not sell them, but here's a few places that do:

Mouser Electronics - http://www.mouser.com/

Radio Daze - http://www.radiodaze.com/

Vacuum Tubes, Inc. - http://www.vacuumtubesinc.com/

Jim Cross, owner of Vacuum Tubes, Inc., is another of the "good guys" in the radio hobby and is deserving of our support.

Basically, you need to know the value of your original mica caps and then order new micas that are at or as close to the original value as possible.

I think most micas have a working voltage of 500 volts DC, which is plenty for nearly any radio application. Some are rated at 300 volts DC which is still enough for many radio circuits using mica caps.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread:
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2145 online users. [Complete List]
» 1 Member(s) | 2144 Guest(s)
Avatar

>