Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Hammarlund HQ-129-X
#31

The tube is likely 6SS7, as the pin 7 is Cathode and should be Grounded, and pin 6 is empty, so probably just grounded for the heck of it. 6SG7 cannot b econnected that way.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#32

What tube are you talking about? All the electrical work is now done. V1, V3, V4, & V5 are all 6SS7. If you look st the schematic I provided you will see that the cathode of a 6SS7 is pin 5
#33

Yesterday I finally got around to painting the cabinet. I sprayed it with primer, and let it dry for about 4 hours, then sprayed it with gray. I let it dry outside until the sun began to set, then brought it inside, and set it up with an electric heater blowing into it to aid in the drying. I'd have pit it in my oven, but it is just a little too tall to fit, so I figure this is the best way. It dried pretty well by the time I went to bed and turned off the heater and checked it. It is dry to the touch, but today I am "cooking" it again just to let it harden more before I reinstall the guts.
#34

The HQ-129-X is DONE. I am listening to WSM in Nashville, to The Grand Old Opry. The set is hooked to my outdoor antenna and ground. It is the best receiver I have worked on. I now remember why I love Hammarlund general coverage receivers. It is connected to my Emerson bookshelf speaker, and sounds great. More important, the reception is everything I remember, better than any of my radios, except perhaps my Scott SLRM, but I would have to test them side by side. Just from my memory I would say they are VERY close, but would give the edge to this Hammarlund. I will make a video of it working soon. This is what it looks like working.
[Image: https://64.media.tumblr.com/75d04cbd9d77...be919a.jpg]
#35

Congrats!

I attended a national meeting at the Opryland Hotel years ago; the place was gigantic.

Got a chance to see the Opry. Got there too late, missed a lot of real Ol' Time and Bluegrass but did catch some. Then the more commercial Country acts came on. (This was about 25 years ago, so I can't remember what the acts were. Still, very nice. I could really like Tennessee!

"Do Justly, love Mercy and walk humbly with your God"- Micah 6:8
"Let us begin to do good"- St. Francis

Best Regards, 

MrFixr55




Users browsing this thread:
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2135 online users. [Complete List]
» 1 Member(s) | 2134 Guest(s)
Avatar

>