Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 29 or 45
#1

Hello, I have just received a Philco lowboy where the tube layout label in the cabinet says 29 or 45. There is no label or markings on the chassis to say which it is. Is there some way to tell what I have? Also my search for a new dial came up empty on Radio Daze does anyone know if I can get one?

Thanks,
Dan
#2

29 chassis has a shadow meter while 45 chassis does not. Shadow meter is part no. 27 in the 29 schematic. compare it to the 45 chassis.
https://philcoradio.com/library/index.ph...ams-vol-1/

...and here's a series of discussions that Ron Ramirez did about his 29/45 restoration. This the link to Part 1 of 7.
https://philcoradio.com/library/index.ph...on-part-1/
#3

Thanks for the info Bob. Looks like a have a 45 (no shadow). Stuffing old paper caps is a bit more than what I care to do. Besides who will ever see them. I restuff electrolytic caps if there is no room under the chassis otherwise I leave the old ones in place disconnected.

Dan




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2232 online users. [Complete List]
» 5 Member(s) | 2227 Guest(s)
AvatarAvatarAvatarAvatar
Avatar

>