Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Correct Pushbuttons and Grille Cloth for 40-185 console
#1

Several months ago I purchased a 40-185 console in almost mint condition from a consignment antique store. I plan to clean up the chassis, recap it, replace the missing pushbuttons, and polish up the finish on the cabinet. I have two questions I need to have answered before I get too far into the restoration project.

Radio Daze has two versions of the octagon buttons used on the 40-185. One set is brown, and the other is rose-colored. Since my old console has no buttons at all, I can't determine which buttons are correct for this model. In addition, the original grille cloth has been removed and replaced by some hideous floral material that looks like it should have been used to upholster a sofa.

If anyone is familiar with the item numbers used by Radio Daze, could you please advise me as to which pushbutton and grille cloth designs are correct for a 40-185.

Thanks!

Mike Harmon, WB0LDJ
mharmon at att dot net
#2

Mike - Welcome!

1940 Philcos such as yours used the translucent red (wine) pushbuttons. The brown buttons are used in 1941 Philco sets.

The correct grillecloth is the Philco "Large Diamond" pattern, #27 from Radio Grille Cloth Headquarters.
http://www.grillecloth.com/
Get it while you can...supplies are limited.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread:
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently no members online.

>