Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Sears silvertone question
#16

Hello I do have a schematic. Don't remember where I got it from. I'll have to dig it out of the file and get back to you.
Do you have the same one with the wire recorder?
#17

I have the same model as described at https://www.radiomuseum.org/r/sears_roeb...01831.html Silvertone 8125 Ch= 101.831-1 Type 47 It's a beauty and complete except for the turntable. I've been searching everywhere to find schematics. Alignment details would also be great.
#18

Until I can get the schematic uploaded to send, and be advised it's not the greatest in regards to clarity,
here is a detailed restoration of one of these consoles in case you haven't seen this.
https://antiqueradios.com/forums/viewtop...r+tone+101
#19

Here is schematic I have and info on alignment. Sorry some pics are sideways.
https://i.imgur.com/e67fLoM.jpg
https://imgur.com/cfbIj7J
https://i.imgur.com/G2AHGwe.jpg
https://i.imgur.com/qwGLjnJ.jpg
https://i.imgur.com/0izQtuL.jpg
#20

Thanks for the files and your link to the restoration discussions of this Silvertone.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Restoration of the Canadian General Electric A-87
Well... While the varnish is drying up, I started repairing the chassis... Of course I started by replacing the pa...RadioSvit — 07:12 AM
Philco Model 38-7: what caps & resistors do fail typically?
Hello Martin, Welcome aboard our little community what great Model 38-7 Sincerely Richardradiorich — 12:30 AM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum Martin. I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM
Part numbers to model cross
Jim, We have this index put together by Dale Cook but I don't think that is quite what you are looking for. The Parts...klondike98 — 09:37 PM
Philco Model 38-7: what caps & resistors do fail typically?
Yep the dim bulb test is OK but I'd definitely replace all those electrolytics before I did it. Since those #47 conden...klondike98 — 09:18 PM
Philco 42-345 Restoration/Repair
The resistor is a 2.2 Meg, it was the last one I hadn't replaced. The broadcast is coming in after replacing it.osanders0311 — 09:09 PM
Philco 42-345 Restoration/Repair
What does the resistor measure? I think it should be 3.3 Meg. If the oscillator coil has continuity and the resistanc...RodB — 09:03 PM
Philco Model 38-7: what caps & resistors do fail typically?
Good idea to check the coils... then I'll get hold of an incadescent light bulb and see what happens when the unit is sw...Musaeum — 08:49 PM
Philco 42-345 Restoration/Repair
I have that same set, ain't too much shortwave I like anyway.....it is a good AM DX set. PaulPaul Philco322 — 08:32 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum, Martin! Open a new thread in Philco Electronic Restoration when you begin working on your 38-7. ...GarySP — 08:28 PM

[-]
Who's Online
There are currently 1215 online users. [Complete List]
» 1 Member(s) | 1214 Guest(s)
Avatar

>