Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

What do I have...
#1

I was given this old Philco cathedral radio and am trying to find out the model and year it was made if possible. There are no markings on the chassis or wooden case that I can see. I hope the pics will tell the story.

I'm sure you guys know...right?

Note from site admin: Sorry, but the photos which were attached to this post are no longer available.

Best regards,
Kico

"I whisper, but my horse still doesn't listen."
#2

Hello, and welcome!

You have a Model 84B, the late version from January 1936:

http://www.philcoradio.com/gallery/1936b.htm#c

That is an oversized power transformer. Might be a 25 cycle model? If so, it will work on today's 60 cycle line current.

--
Ron Ramirez
Ferdinand IN
#3

Thanks Ron,

I tested all the tubes and they all check good. I then fired it up on my dim bulb tester...as expected a very loud 60 cycle hum but no smoke Icon_smile...faulty power supply cap I suspect.

Any good links here on the forum for rebuilding one of these?

Thanks again...

Best regards,
Kico

"I whisper, but my horse still doesn't listen."
#4

You may want to search this site for similar models like model 80,84,600, 57,37-84.
Terry

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#5

7estatdef Wrote:You may want to search this site for similar models like model 80,84,600, 57,37-84.
Terry

Thanks Terry,

Whew...there's a lot here. I was wondering if anybody has compiled a component list (caps/resistors, etc.) needed for rebuilding an 84B they could post or send me? My eyes are not what they used to be, and reading the actual and schematic values is difficult. I'd like make sure I have the correct parts before I place an order.

Also, could someone on the forum link me to the correct schematic for this radio...thanks.

Best regards,
Kico

"I whisper, but my horse still doesn't listen."
#6

May I suggest you contact Chuck Schwark to obtain the service information package for this radio, which will include an 11 x 17 enlarged schematic, parts list, alignment info, changes, etc., etc.

http://www.philcorepairbench.com/schematics.htm

Well worth the nominal fee.

--
Ron Ramirez
Ferdinand IN
#7

Thanks Ron...I'll do it!

Best regards,
Kico

"I whisper, but my horse still doesn't listen."
#8

Hi Ron,
I am working on one of these right now, the exact same cabinet. But the inside label says it's just a model 84. Does the 84B just refer to the style of cabinet, and is not marked so on the blue tag?
I do have another 84 but with the more circular cabinet.

Kico, I posted some photos an info for you on your other thread.

Thanks. Gary.
#9

Hi Gary

Yes, the "B" referred to the style of cabinet; in this case, "B" = Baby Grand - which is how Philco referred to its cathedrals and tombstones back then. The terms "cathedral" and "tombstone" did not come into general use until decades later, as people like us began to collect these radios.

The sticker on the back of the chassis will read "CHASSIS TYPE 84" without mentioning the cabinet style.

--
Ron Ramirez
Ferdinand IN
#10

Thanks Ron, that clears up the mystery.

Working on the cabinet today, shouldn't be too bad. No veneer or photofinish to worry about.

Take care,
Gary




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
The list of my radio & TV collection!
Ok. Everything opens with a direct link. Yes. As Arran said, this is a transistor radio. It is a more expensive version ...RadioSvit — 03:07 PM
Electrolytic restuffing/internals
Gary I thought the same, but then isn't a hacksaw by definition is the one with fine teeth? >>A hacksaw is a...morzh — 03:01 PM
The list of my radio & TV collection!
Ah a KiJiJi seller! I've noticed that KiJiJi tends to be where all of the rejects from craigslist go, not that there ...Arran — 01:43 PM
Electrolytic restuffing/internals
When I'm lazy, I use a razor knife with a new blade. Nice smooth, even cut, minimal loss of material and no trimming or ...RodB — 01:39 PM
Electrolytic restuffing/internals
I still disagree with your sawing or cutting method. It is much easier in terms of the opening method and better in term...Vlad95 — 01:29 PM
Electrolytic restuffing/internals
For the question about the jagged hacksaw cut, the most common reason is too aggressive 'bite' of the saw blade. I use ...GarySP — 01:26 PM
Electrolytic restuffing/internals
Well I retire in about three years. My plan is to build a better workshop that has an area for these kinds of things. ...bridkarl — 01:14 PM
Electrolytic restuffing/internals
Ido remember you telling us about your health condition. Yes, a vise is a good thing to have. Many things I do I woul...morzh — 01:08 PM
The list of my radio & TV collection!
Strange, the second link works for me without problems. Try this direct link. Or try searching for "AKKORD DELUX ...Vlad95 — 01:08 PM
The list of my radio & TV collection!
Looks like Peter and I have the same idea.RodB — 11:37 AM

[-]
Who's Online
There are currently 823 online users. [Complete List]
» 2 Member(s) | 821 Guest(s)
AvatarAvatar

>