Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Help!! I don’t know the model
#1

Hi there, I just bought this the other day at a resale shop so there was no info about it other than “record player table”. I figured out the brand by myself but cannot for the life of me figure out the model. The turntable needs a new needle so that’s why I need the model, I believe there is another piece missing as well, also on the turntable. Any information would be fantastic, thanks in advance!!


Attached Files Image(s)
                   
#2

Looks like a 60s model. I believe Philco used Voice of Music changers in the consoles. You probably have to take a closer look at the cartridge to match a needle. Quite often the original cartridge has been replaced.
#3

Hi and welcome,
There's a possibility that the radio and the phono where sold as separate units. In this case the model number would be on found on each component.
As for the needle/cartridge I'd give these guys a try: https://thevoiceofmusic.com/catalog/phono_needles.asp  You may be able to send them a pic of what you have and go from there.

GL with w/project!

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#4

That is very nice...  Something I am more familiar with have a similar VM unit my first wife just had to have..
Early American or Colonial design, I never cared for the Spanish or Mediterranean designs...  He, he, the V-M worked right up to the day she hauled it away during the divorce Icon_lol

BTW it was Solid-State, went through at least 6 needles and one ceramic cart. My favorite album was "Switched on Bach" at near full volume, she hated it...

Pliny the younger
“nihil novum nihil varium nihil quod non semel spectasse sufficiat”




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco Model 38-7: what caps & resistors do fail typically?
Hello Martin, Welcome aboard our little community what great Model 38-7 Sincerely Richardradiorich — 12:30 AM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum Martin. I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM
Part numbers to model cross
Jim, We have this index put together by Dale Cook but I don't think that is quite what you are looking for. The Parts...klondike98 — 09:37 PM
Philco Model 38-7: what caps & resistors do fail typically?
Yep the dim bulb test is OK but I'd definitely replace all those electrolytics before I did it. Since those #47 conden...klondike98 — 09:18 PM
Philco 42-345 Restoration/Repair
The resistor is a 2.2 Meg, it was the last one I hadn't replaced. The broadcast is coming in after replacing it.osanders0311 — 09:09 PM
Philco 42-345 Restoration/Repair
What does the resistor measure? I think it should be 3.3 Meg. If the oscillator coil has continuity and the resistanc...RodB — 09:03 PM
Philco Model 38-7: what caps & resistors do fail typically?
Good idea to check the coils... then I'll get hold of an incadescent light bulb and see what happens when the unit is sw...Musaeum — 08:49 PM
Philco 42-345 Restoration/Repair
I have that same set, ain't too much shortwave I like anyway.....it is a good AM DX set. PaulPaul Philco322 — 08:32 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum, Martin! Open a new thread in Philco Electronic Restoration when you begin working on your 38-7. ...GarySP — 08:28 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum! :wave: Here's the schematic for that radio from our digital library: Something to do bef...klondike98 — 08:05 PM

[-]
Who's Online
There are currently no members online.

>