Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 37-670 problem finally solved
#1

My 37-670 would play well for a few minutes and then lose volume to the point that you could not hear the station at all. Simultaneously the shadowmeter went completely black. I put off working on it, mainly because it is large, heavy, and a pain in the (thing one sits on) to lug off the relatively high place it occupies, transport to my work table, and take apart. Today I stopped putting it off and gave myself a healthy dose of pain in my (thing I siit on) getting it to my work table and apart.

Long story short: problem was a 6K7G tube (IF amplifier) that tests good on my tester when "cold" but tests bad when "hot."

First time I have had a tube issue like this.

The radio played for over an hour after replacing the 6K7G, so believe problem solved.

Color me pleased and (thing I sit on) sore.
#2

Before you toss that 6K7, try resoldering the pins on the base as well as the grid cap, particularly the cathode pin, I found a 6K6 tube like that lately, tube lit up but no reading.
Regards
Arran
#3

Great advice! I'll do that.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently no members online.

>