Posts: 7,323
Threads: 270
Joined: Dec 2009
City: Roslyn Pa
I sent an email to Michael Katz to inquire about the chevron cloth. He's working with the fabric manufactures on getting it in stock and to check back in a few months. So hopefully we will have a source in the near future. He's also looking into reproducing the '38-'39 cloth too.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got it!
Terry
(This post was last modified: 05-02-2022, 09:00 PM by
Radioroslyn.)
Posts: 350
Threads: 33
Joined: Aug 2017
City: Hay Lakes, Alberta,Canada
Very good news!
Posts: 13
Threads: 0
Joined: Apr 2021
City: Seaford
State, Province, Country: New York
Hi guys. More grille cloth news. In addition to receiving the "scalloped" Zenith 7 S 363 pattern, I just received samples of the Philco 16B "V" pattern, and an RCA R-28-P "horseshoe" pattern, and have given the go ahead to the mill for both. Should have them within 2 - 3 months, I hope. Also seeing if they can do a decent reproduction of the large Philco console V pattern as well, and maybe the RCA wheat pattern. It all takes time though.
I will be at Kutztown - table 415 - starting tomorrow.
Michael Katz
(This post was last modified: 07-07-2022, 01:52 PM by
Michael Katz.)
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand
State, Province, Country: Indiana
The RCA wheat pattern would be a wonderful addition to your line of reproduction cloth!
And for those of you who cannot make it to Kutztown, you can reach Michael through his website:
https://www.radiogrillecloth.com/
--
Ron Ramirez
Ferdinand IN
Posts: 13
Threads: 0
Joined: Apr 2021
City: Seaford
State, Province, Country: New York
Hi Ron. I did give in a sample of the wheat pattern and the large chevron. Haven't heard back yet. I also posted on this site that I received 5 new patterns, one is the Philco 16B V pattern. I do need to know the sizing to cut it to, as I don't have any Philcos using this pattern.
Posts: 13
Threads: 0
Joined: Apr 2021
City: Seaford
State, Province, Country: New York
Hi Ron (and others). I have just received the Philco V pattern for the 16B, 37-116, and other sets. Since I don't have any Philcos using this, can you provide me with an idea of what sizes I should cut it to, including overlap? The V is 20 1/2 inches wide, and I can cut it as long as any radio needs. I know there are some smaller sets than the consoles. Thanks. Michael.
Posts: 3,187
Threads: 226
Joined: May 2008
City: Omak
State, Province, Country: WA
hello Everyone,
This great news !
Sincerely Richard
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
