Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco radio with phono input
#1

Does anyone know if Philco made a radio with a phono input?  In the 50’s I had a record changer with crystal cartridge and what I seem to remember is a Philco radio
with a phono jack. Radio long gone, but I still have the changer. They were a present from an older brother, along with a stack of children’s records. 
Thanks
Thom.
#2

Hi Thom,

Hmmm...the only Philcos I can think of offhand with a phono input are Philco Tropic radios, along with one domestic model which is basically part of the Tropic family - model 53-960. That is a rather large radio, however. I'm guessing the set you had was smaller?

--
Ron Ramirez
Ferdinand IN
#3

The radio I remember was a smaller one in a vertical cream plastic case. Phono jack was on the right side looking at the front. This was over 60 years ago, so might not have been a Philco.
Thom.
#4

They were adding phono inputs optionally without them being on the original schematic. Don't ask me how I know.
#5

I can't remember if it was a Philco or an Emerson, but I fixed one that had an RCA style phono jack on the right side. On this model, when you plugged the phono into this jack, the radio would be disconnected, much like a headphone jack does.

I have 2 Zenith AM FM H7XX models, an RCA 1R81 and 2 GEs, all with RA Phone Jacks. Most have radio / phono switches. the 2GEs are mid 50s clock radios. Turning the volume pot CW makes the radio louder and the phono lower, turning it CCW makes the radio lower, and the phono input louder.

"Do Justly, love Mercy and walk humbly with your God"- Micah 6:8
"Let us begin to do good"- St. Francis

Best Regards, 

MrFixr55
#6

I've seen some Canadian Philco models with an RCA phono jack, but those were at the rear, not in the side of the cabinet. It really depends on what model in what year, the ones that were clones of U.S Philcos did not have them, except for the Philco Tropic clones, my Bing Crosby does not. 
Regards
Arran




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2255 online users. [Complete List]
» 1 Member(s) | 2254 Guest(s)
Avatar

>